Results 101 to 110 of about 87,104 (294)
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
A Workflow to Accelerate Microstructure‐Sensitive Fatigue Life Predictions
Advanced Engineering Materials, EarlyView.This study introduces a workflow to accelerate predictions of microstructure‐sensitive fatigue life. Results from frameworks with varying levels of simplification are benchmarked against published reference results. The analysis reveals a trade‐off between accuracy and model complexity, offering researchers a practical guide for selecting the optimal ...
Luca Loiodice +2 more
wiley +1 more source
An Intelligent Maximum Power Point Using a Fuzzy Log Controller under Severe Weather Conditions
International Journal of Photoenergy, 2018 This study is aimed at providing a comparison between fuzzy systems and convectional P&O for tracking MPP of a PV system. MATLAB/Simulink is used to investigate the response of both algorithms.
Khaled Bataineh
doaj +1 more source
Oxide‐Free Titanium Coatings by Wire Arc Spraying in a Silane‐Doped Inert Atmosphere
Advanced Engineering Materials, EarlyView.A silane‐doped argon atmosphere enables the production of oxide‐free titanium coatings via twin‐wire arc spraying at ambient pressure. This innovative approach eliminates residual oxygen, creating process conditions that prevent oxidation and nitride formation.
Manuel Rodriguez Diaz +4 more
wiley +1 more source
Effect of Patterned Slip on Micro and Nanofluidic Flows
, 2005 We consider the flow of a Newtonian fluid in a nano or microchannel with walls that have patterned variations in slip length. We formulate a set of equations to describe the effects on an incompressible Newtonian flow of small variations in slip, and ...
C. Cottin-Bizonne +7 more
core +1 more source
Assessing Altered Coating Adhesion on Plasma‐Deoxidized Surfaces Under Oxygen‐Free Conditions
Advanced Engineering Materials, EarlyView.This study demonstrates the effectiveness of atmospheric pressure plasma pretreatment in modifying silicon and stainless steel surfaces to improve adhesion. Argon‐hydrogen plasma increases surface roughness and improves adhesion strength, whereas pure argon results in smoother surfaces and structural changes.
Selina Raumel +6 more
wiley +1 more source
Mayfly Optimization Algorithm for MPPT of PV System under Partial Shading Conditions [PDF]
E3S Web of ConferencesMaximum power point tracking (MPPT)methods are most popular to harvest maximum energy from renewable energy sources for generating electric power. Among many renewable energy sources, solar energy is a primary and mostly available on the earth. Generally
Pratap Singh Akhilendra +3 more
doaj +1 more source
Surface Tension Measurement of Ti‐6Al‐4V by Falling Droplet Method in Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.In this article, the temperature‐dependent surface tension of free falling, oscillating Ti‐6Al‐4V droplets is investigated in both argon and monosilane doped, oxygen‐free atmosphere. Droplet temperature and oscillation are captured with one single high‐speed camera, and the surface tension is calculated with Rayleigh's formula.
Johannes May +9 more
wiley +1 more source
Analysis of single-cell shading impact on polycrystalline PERC module under hot-dry conditions
Energy Conversion and Management: XPV technologies may often perform differently under outdoor operating conditions compared with Standard Test Conditions, which are performed under a controlled setup inside a laboratory.
Neha Kumari +3 more
doaj +1 more source
Linear Differential Constraints for Photo-polarimetric Height Estimation
, 2017 In this paper we present a differential approach to photo-polarimetric shape estimation. We propose several alternative differential constraints based on polarisation and photometric shading information and show how to express them in a unified partial ...
Hancock, Edwin R. +4 more
core +1 more source