Results 191 to 200 of about 6,416,888 (307)

Interplay between gelation and glass formation in silica nanoparticle colloids. [PDF]

Sci Rep
Gerardi G, Alba-Simionesco C, Pépin M, Davaille A.   +3 more
europepmc   +1 more source

Effect of alfalfa forage preservation method and particle length on performance of dairy cows fed corn silage-based diets and tallow.

Journal of Dairy Science, 2004
S. Onetti, S. Reynal, R. Grummer
semanticscholar   +1 more source

Triple Junctions as Dislocation‐Like Defects: The Role of Grain Boundary Crystallography Revealed by Experiment and Atomistic Simulation

Advanced Engineering Materials, EarlyView.
Grain boundary triple junctions are an essential ingredient of the microstructure of polycrystalline materials. In this study, a triple junction is observed using atomic‐resolution scanning transmission electron microscopy and characterized. Computer simulations reveal that the junction has a dislocation character that is determined by the joining ...
Tobias Brink, Saba Saood, Peter Schweizer, Jörg Neugebauer, Gerhard Dehm   +4 more
wiley   +1 more source

A Swirling-Flow-Enhanced Triboelectric Nanogenerator for Improved Dilute-Phase Particle Sensing. [PDF]

Sensors (Basel)
Zhang M, Zhang B, Li Z, Zhang J, Luo Y, Yue Z.   +5 more
europepmc   +1 more source

Microstructure, Thermal Transport, and Dry‐Sliding Tribology of Powder‐Metallurgy Al7075 Composites Reinforced With Sol–Gel‐Derived ZnO–rGO Hybrid Nanoparticles

Advanced Engineering Materials, EarlyView.
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal, Cevher Kursat Macit, Merve Ayık, Hakan Tutumlu   +3 more
wiley   +1 more source

Detecting directed motion and confinement in single-particle trajectories using hidden variables. [PDF]

Elife
Simon F, Ramadier G, Fonquernie I, Zsok J, Patskovsky S, Meunier M, Boudoux C, Dultz E, Weiss LE.   +8 more
europepmc   +1 more source

Advanced Electron Microscopy and Microcomputed Tomography Analysis of Single‐Crystal Ni‐Base Superalloys After Short‐Term Multiaxial Creep

Advanced Engineering Materials, EarlyView.
This work studies the anisotropic behavior of circular notched tensile specimens of Ni‐base superalloy single crystals during high‐temperature tensile creep along [001], [110], and [111]. Correlative scale‐bridging imaging of specimens reveals early rupture along [110] because 1) plastic deformation proceeds faster at notch center; 2) more (brittle ...
Leonardo Agudo Jácome, Lijie Cao, Christoph Somsen, Johannes Boes, René Hesse, Werner Theisen, Gunther Eggeler   +6 more
wiley   +1 more source

Upper Bounds on the Colloid Separation Efficiency of Diffusiophoresis. [PDF]

Langmuir
Temprano-Coleto F, Kim J, Louis MM, Stone HA.   +3 more
europepmc   +1 more source

Defect Evolution and Mechanical Performance of Fused Filament Fabrication‐Manufactured 17‐4PH Stainless Steel Revealed by X‐Ray Computed Tomography

Advanced Engineering Materials, EarlyView.
X‐ray computed tomography reveals how process‐induced defects evolve from green to sintered states in Fused Filament Fabrication (FFF)‐manufactured 17‐4PH stainless steel. Internal porosity, weakest cross‐sections, and fracture locations show strong correlation with tensile performance, demonstrating the potential of computed tomography (CT)‐based ...
György Ledniczky, Márk Sárközi, Ibolya Zsoldos, Zoltán Weltsch   +3 more
wiley   +1 more source

Almond shell as an insoluble fibre source in laying pullets: influence of inclusion level and particle size on performance and intestinal health. [PDF]

Vet Anim Sci
Ruiz E, Montalbán A, Ayala L, Sánchez CJ, Hernández F, Madrid J, Ortega N, Rodríguez M, Martínez-Miró S.   +8 more
europepmc   +1 more source