Results 91 to 100 of about 349,191 (315)
The dayside particle precipitation during the passage of a solar wind rotational discontinuity (RD) event on 10 April 2015 is examined and reviewed. The RD leads to complex structures at the magnetopause, boundary layer, mantle, and cusp even though the ...
Simon Wing +3 more
doaj +1 more source
The relationships between high latitude convection reversals and the energetic particle morphology observed by the Atmosphere Explorer [PDF]
Simultaneous measurements of the auroral zone particle precipitation and the ion convection velocity by Atmosphere Explorer show a consistent difference between the location of the poleward boundary of the auroral particle precipitation and the ion ...
Burch, J. L. +3 more
core +1 more source
Zein‐Based Adhesives: Sustainable Extraction and Application in Bioadhesive Technologies
Zein is extracted from corn gluten meal using a simple and scalable process with high yield (~90%). The resulting protein is applied in bioadhesives modified with Ca2+ and Fe3+ ions, exhibiting substrate‐dependent adhesion. The findings demonstrate competitive bonding performance and highlight the role of ionic interactions in tuning adhesion ...
Paula Bertolino Sanvezzo +3 more
wiley +1 more source
Relation of energetic particles in the plasma sheet to the auroral zone [PDF]
Relationship of plasma and energetic particles in geomagnetic tail to particle precipitation into auroral ...
Anderson, K. A.
core +1 more source
Inward electrostatic precipitation of interplanetary particles [PDF]
An inward precipitator collects particles initially dispersed in a gas throughout either a cylindrical or spherical chamber onto a small central planchet. The instrument is effective for particle diameters greater than about 1 µm.
Ahrens, Thomas J. +2 more
core +2 more sources
Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar +2 more
wiley +1 more source
Multiscale Poromechanics of Wet Cement Paste [PDF]
Capillary effects such as imbibition-drying cycles impact the mechanics of granular systems over time. A multiscale poromechanics framework was applied to cement paste, that is the most common building material, experiencing broad humidity variations ...
Bazant, Martin Z. +4 more
core +3 more sources
This study investigates the tribological response of 60NiTi alloy under dry, water‐lubricated and high‐temperature conditions. The alloy exhibits decreasing wear volume and friction with increasing temperature due to the formation of protective oxide layers. The work clarifies dominant wear mechanisms and demonstrates the suitability of 60NiTi for high‐
Anthony Onyebuchi Okoani +2 more
wiley +1 more source
Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Trace additions of Sn and Sr combined with a two‐step aging treatment are shown to enhance the microstructure and performance of Al–Zr–Sc conductor alloys. Strength and electrical conductivity increase concurrently through accelerated precipitation of fine Al3(Sc, Zr) precipitates and improved dislocation resistance, offering a cost‐effective pathway ...
Quan Shao +3 more
wiley +1 more source

