Results 171 to 180 of about 19,560 (246)
Derivation of Equivalent Material Coefficients of 2-2 Piezoelectric Single Crystal Composite. [PDF]
Sim M, Je Y, Cho Y, Seo HS, Kim MJ.
europepmc +1 more source
High-Power Characteristics of Piezoelectric Transducers Based on [011] Poled Relaxor-PT Single Crystals. [PDF]
Lim S +6 more
europepmc +1 more source
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Journal of the American Chemical Society, 2022
Ferroelectric materials hold great promise in the field of photocatalytic water splitting due to their spontaneous polarization that sets up an inherent internal field for the spatial separation of photogenerated charges.
G. Wan +13 more
semanticscholar +1 more source
Ferroelectric materials hold great promise in the field of photocatalytic water splitting due to their spontaneous polarization that sets up an inherent internal field for the spatial separation of photogenerated charges.
G. Wan +13 more
semanticscholar +1 more source
Internal‐Field‐Enhanced Charge Separation in a Single‐Domain Ferroelectric PbTiO3 Photocatalyst
Advances in Materials, 2020Ferroelectric materials with spontaneous polarization‐induced internal electric fields have drawn increasing attention in solar fuel production due to the intrinsic polarized structure.
Yong Liu +12 more
semanticscholar +1 more source
Giant Uniaxial Strain Ferroelectric Domain Tuning in Freestanding PbTiO3 Films
Advanced Materials Interfaces, 2020Dimensionality and epitaxial strain have been recently utilized to engineer the interplay between the electrostatic and elastic energies to stabilize exotic ferroelectric domain structures and topological textures in epitaxial heterostructures and ...
Lu Han +6 more
semanticscholar +1 more source
Antiferroelectriclike hysteresis loops in PbTiO3/BiFeO3/PbTiO3 sandwich structural film
Solid State Communications, 2008Abstract PbTiO3/BiFeO3/PbTiO3 sandwich structure has been deposited on Pt/Ti/SiO2/Si substrate by sol-gel method annealing at 600 ∘C. X-ray diffraction analysis revealed that the film was fully crystallized with no impure phase. Antiferroelectriclike hysteresis loop was observed at room temperature under low applied field. Under high applied electric
Hongri Liu, Xiuzhang Wang
openaire +1 more source
Giant piezoelectricity of Sm-doped Pb(Mg1/3Nb2/3)O3-PbTiO3 single crystals
Science, 2019Samarium supersensors Piezoelectric materials produce electric charge in response to changes in stress and are thus good sensor materials. One challenge has been growing single-crystal piezoelectrics with uniform properties.
Fei Li +14 more
semanticscholar +1 more source
Absence of a PbTiO3 phase transition in PbTiO3/BaTiO3 superlattices
Journal of the European Ceramic Society, 2001Abstract We have performed X-ray diffraction and Raman spectroscopy on three PbTiO 3 /BaTiO 3 superlattices (PTO/BTO) from room temperature (RT) to 600°C. The superlattices were 4000 A thick and the modulation wavelengths Λ, with equally thick layers of PTO and BTO, were 136, 187 and 357 A.
F Le Marrec +4 more
openaire +1 more source
Journal of Applied Physics, 2020
Compared with the state-of-the-art Pb(Zr,Ti)O3 ceramics, relaxor-PbTiO3 (PT) based ferroelectric single crystals possess much higher piezoelectricity, thus receiving considerable attention from the ferroelectric community. Recently, it was found that the
Jinfeng Liu +6 more
semanticscholar +1 more source
Compared with the state-of-the-art Pb(Zr,Ti)O3 ceramics, relaxor-PbTiO3 (PT) based ferroelectric single crystals possess much higher piezoelectricity, thus receiving considerable attention from the ferroelectric community. Recently, it was found that the
Jinfeng Liu +6 more
semanticscholar +1 more source
Journal of Materials Science, 1985
The sol-gel process is a technique which is applicable for forming ceramic materials. In this process, liquid precursor materials are reacted to form a sol which then polymerizes into an inorganic polymeric gel. Advantages of this process over standard powder preparation of ceramics are: purity, homogeneity, control of macro- and micro-structures, and ...
J. B. Blum, S. R. Gurkovich
openaire +1 more source
The sol-gel process is a technique which is applicable for forming ceramic materials. In this process, liquid precursor materials are reacted to form a sol which then polymerizes into an inorganic polymeric gel. Advantages of this process over standard powder preparation of ceramics are: purity, homogeneity, control of macro- and micro-structures, and ...
J. B. Blum, S. R. Gurkovich
openaire +1 more source

