Results 191 to 200 of about 8,898 (229)
Some of the next articles are maybe not open access.

A Quantitative Study of PCBM Diffusion during Annealing of P3HT:PCBM Blend Films

Macromolecules, 2009
Scanning transmission X-ray microscopy has been used to quantitatively map the composition of P3HT:PCBM blend films in the vicinity of PCBM crystals formed during annealing at 140 °C. The observed PCBM concentration profiles around these crystals have been fitted to Fick’s second law of diffusion and the diffusion constant found to be 2.5 × 10−14 m2 s ...
Watts, Benjamin   +4 more
openaire   +2 more sources

A layered structure at the surface of P3HT/PCBM blends

Physical Chemistry Chemical Physics, 2011
In an organic photovoltaic device, a layer consisting of two organic compounds, one functioning as an electron acceptor and the other as an electron donor, is sandwiched between two electrodes. Sufficient concentration of the electron acceptor is required at the interface to the low work function electrode as well as sufficient concentration of the ...
Natalya, Schmerl, Gunther, Andersson
openaire   +2 more sources

Microstructure and Optoelectronic Properties of P3HT-b-P4VP/PCBM Blends: Impact of PCBM on the Copolymer Self-Assembly

Macromolecules, 2013
Block copolymers have been widely investigated over the past decades for their ability to microphase separate into well-defined nanostructured thin films with tailored physical properties. The aim of the present study is to investigate the thin film properties of rod–coil block copolymer/phenyl-C61-butyric acid methyl ester (PCBM) blends as a function ...
Gernigon, Véronique   +10 more
openaire   +1 more source

Energetics of Electron–Hole Separation at P3HT/PCBM Heterojunctions

The Journal of Physical Chemistry C, 2013
The energetics of electron–hole separation at the prototypical donor–acceptor interface P3HT/PCBM is investigated by means of a combination of molecular dynamics simulations, quantum-chemical methods, and classical microelectrostatic calculations. After validation against semiempirical Valence Bond/Hartree–Fock results, microelectrostatic calculations ...
Gabriele D’Avino   +7 more
openaire   +4 more sources

Solubility of C60 and PCBM in Organic Solvents

The Journal of Physical Chemistry B, 2015
The ability to correlate fullerene solubility with experimentally or computationally accessible parameters can significantly facilitate nanotechnology nowadays for a wide range of applications, while providing crucial insight into optimum design of future fullerene species.
Chun I, Wang, Chi C, Hua
openaire   +2 more sources

Effect of UV-Ozone Exposure on PCBM

IEEE Journal of Photovoltaics, 2012
The effect of ultraviolet (UV)-light ozone exposure on phenyl-C61-butyric acid methyl ester (PC61BM) is studied using solid-state modification of the material. In this study, solution processed PCBM films that have been deposited and dried over glass were exposed to UV ozone at ambient temperature and pressure from 0 to 120 min.
Amare Benor Belay   +5 more
openaire   +2 more sources

On the Growth of Evaporated LiF on P3HT and PCBM

The Journal of Physical Chemistry C, 2018
The electronic properties of thin layers of LiF evaporated onto phenyl-C61-butyric acid methyl ester and poly(3-hexylthiophene) thin films have been examined to better understand how alkali halide salt layers at the interface between the metal electrode and the organic conducting material improve device performance.
N. M. Schmerl   +2 more
openaire   +1 more source

P3HT/PCBM/SWNTs photovoltaic devices

SPIE Proceedings, 2008
It is shown that the introduction of functionalized single-walled carbon nanotubes SWNTs in bulk heterojunction polymer-fullerene photovoltaic devices results in an improvement of both the short circuit current density and the fill factor. An optimum performance with a power conversion efficiency of 1.4% is obtained with 0.5 wt% of SWNTs in a (1:1 ...
Emmanuel Kymakis, Emmanuel Koudoumas
openaire   +1 more source

A photophysical study of PCBM thin films

Chemical Physics Letters, 2007
Abstract The photophysical properties of [6,6]-phenyl C 61 butyric acid methyl ester (PCBM) are found to differ depending on its concentration in thin films. A film of dispersed PCBM molecules in polystyrene (PS) showed only weak absorption in the visible region (400–700 nm) with a single S 1  → S 0 emission band at around 700 nm.
Cook, Steffan   +5 more
openaire   +1 more source

Polymerization and tuning optical property of PCBM

2011 37th IEEE Photovoltaic Specialists Conference, 2011
Solution processable organic photovoltaics (PV) materials with improved optical properties are required for enhanced device efficiency and ease of manufacture or development. In this study, polymerization and improved optical properties of phenyl-C61-buryric acid methyl ester (PC60BM) or PCBM is achieved through the use of UV-ozone exposure and ...
Amare B. Belay   +4 more
openaire   +1 more source

Home - About - Disclaimer - Privacy