Results 111 to 120 of about 257,276 (158)
Some of the next articles are maybe not open access.
Peak-to-Average Power Ratio Reduction in MIMO OFDM
2007 IEEE International Conference on Communications, 2007Peak-to-average power ratio (PAR) reduction in OFDM using antenna arrays (MIMO OFDM) is considered. In particular, generalizations of selected mapping (SLM) recently proposed in literature, are studied, and a new version, we call it directed SLM (dSLM), is introduced.
Robert F. H. Fischer, Martin Hoch
openaire +1 more source
Peak to Average Power Ratio sensor for green Cognitive Radio
21st Annual IEEE International Symposium on Personal, Indoor and Mobile Radio Communications, 2010High Peak to Average Power Ratio (PAPR) is a critical issue in multi-standard and multi-carrier communication systems. This problem can result in large performance degradation due to the non-linearity of the High Power Amplifier (HPA) or in low power efficiency.
Palicot, Jacques +2 more
openaire +2 more sources
On minimizing the peak-to-average power ratio for the sum of N sinusoids
IEEE Transactions on Communications, 1993A new derivation is presented of a previously known relationship for phasing N equal-amplitude, equally spaced (in frequency) sinusoids so that the peak-to-average power ratio of their sum is 2.6 dB. The method of derivation provides intuitive insight into why this result is possible, and shows that the 2.6 dB figure is obtained independently of N as ...
Darrell R. Gimlin, Charles R. Patisaul
openaire +2 more sources
2011 XXXth URSI General Assembly and Scientific Symposium, 2011
For conventional RF power amplifier (PA), the power efficiency depends on the peak to average power ratio (PAPR) of the input signal, or more precisely on the statistical distribution of the input signal amplitude. In this paper we show that, in a similar way, the power efficiency of switching mode PA driven by ΣΔ or PWM signals depends on the ...
Baudoin, Geneviève +2 more
openaire +2 more sources
For conventional RF power amplifier (PA), the power efficiency depends on the peak to average power ratio (PAPR) of the input signal, or more precisely on the statistical distribution of the input signal amplitude. In this paper we show that, in a similar way, the power efficiency of switching mode PA driven by ΣΔ or PWM signals depends on the ...
Baudoin, Geneviève +2 more
openaire +2 more sources
International Journal of Electrical Power and Energy Systems, 2021
Yuguang Niu, Ming Du, Xiao Qi
exaly
Yuguang Niu, Ming Du, Xiao Qi
exaly
Controlling peak-to-average power ratio reduction
2022CARLSSON ROLAND, MÄLLO AARE
openaire +2 more sources

