Results 41 to 50 of about 9,227 (221)
A HYBRID TECHNIQUE FOR PAPR REDUCTION OF OFDM USING DHT PRECODING WITH PIECEWISE LINEAR COMPANDING [PDF]
Orthogonal Frequency Division Multiplexing (OFDM) is a fascinating approach for wireless communication applications which require huge amount of data rates.
Thammana Ajay, K. Murali Krishna
doaj
Research on Low-complexity PAPR Reduction Algorithm in Radar-communication Integrated System [PDF]
This paper proposes a low-complexity Peak to Average Power Ratio(PAPR) reduction algorithm to deal with the high PAPR of radar-communication integrated system of Orthogonal Frequency Division Multiplexing(OFDM) based on Fractional Fourier Transform(FRFT).
CHEN Kangrun,LIU Yang,ZHANG Wei
doaj +1 more source
Analysis of Hybrid PAPR Reduction Methods of OFDM Signal for HPA Models in Wireless Communications
Orthogonal Frequency Division Multiplexing (OFDM) suffers from a high Peak-to-Average Power Ratio (PAPR). Designing a High Power Amplifier (HPA) with high PAPR is not a wise technique as it roots the amplifier to operate in a non-linear region which is ...
Sravanti Thota +2 more
doaj +1 more source
The potential gains of NOMA were evaluated in a satellite system with heterogeneous receivers, after considering the use of specific DVB‐S2X MODCODs, along with the impact of non‐linearities. It was concluded that a judicious power allocation in NOMA, jointly optimized with the IBO of the PAs, can yield significant sum‐rate gains.
Tomás Ramírez, Carlos Mosquera
wiley +1 more source
Peak-to-average power ratio reduction based on cross-correlation in OFDM systems [PDF]
Two of the most important techniques of Peak-to-average power ratio (PAPR) reduction in orthogonal frequency division multiplexing (OFDM) systems are Partial Transmit Sequence PAPR (PTS-PAPR) and Cross-Correlation-PTS.
Hashim, Shaiful Jahari +5 more
core +1 more source
Research on Peak‐to‐Average Power Ratio Control Method for Switched Reluctance Pulse Generator
Addressing the different requirements for peak output power when SRPG supplies power to pulse loads and DC loads, the peak‐to‐average power ratio (PAPR) is taken as the generation performance optimisation parameter. By investigating the power characteristics of the SRPG, the influence of control parameters on the PAPR is studied.
Yanting Liu +4 more
wiley +1 more source
Spectrally Compatible Deceptive Jamming Waveform Design for Synthetic Aperture Radar Countermeasures
This paper focuses on the design of synthetic aperture radar (SAR) deceptive jamming waveforms with spectrum‐compatible capability. By using the synthesised jamming waveform, successful deception against the hostile SAR system is demonstrated by generating false targets with high fidelity in both range and azimuth.
Yuhao Chen +4 more
wiley +1 more source
The sixth generation (6G) wireless networks are used to provide a large coverage, and also this generation needed to support different emerging applications in harsh areas with higher user equipment mobility. For the above case, a new modulation technique called orthogonal time–frequency space (OTFS) modulation has emerged as a promising technique to ...
Ephrem Gelamite Demere +2 more
wiley +1 more source
Closed-form approximations of the peak-to-average power ratio distribution for multi-carrier modulation and their applications [PDF]
International audienceThe theoretical analysis of the peak-to-average power ratio (PAPR) distribution for an orthogonal frequency division multiplexing (OFDM) system, depends on the particular waveform considered in the modulation system.
Chafii, Marwa +2 more
core +3 more sources
ABSTRACT In this article, we provide a novel, expanded, and adapted pruning approach for the Simplified Volterra Series (SVS) model that makes it applicable to a wider range of Power Amplifiers (PAs). The proposed Modified SVS (MSVS) model is then applied in a Digital Predistortion (DPD) architecture to linearize a 25 W Gallium Nitride (GaN) RF PA.
Haithem Rezgui +3 more
wiley +1 more source

