Results 251 to 260 of about 1,753,859 (288)
Some of the next articles are maybe not open access.
Control system for Peltier element air dryer
2014 International Conference on Mechanical Engineering, Automation and Control Systems (MEACS), 2014In this work control system for Peltier element air dryer is shown. The block diagram of an air dryer and schematic diagram of a control system are presented.
I.S. Musorov +4 more
exaly +2 more sources
LTspice-model of thermoelectric Peltier-Seebeck element
2016 IEEE 36th International Conference on Electronics and Nanotechnology (ELNANO), 2016A simple, symmetric, convertible into electric generator mode LTspice-model of Peltier-Seebeck element is proposed. The model parameters are extracted from the experimental measurement results of the electrical and thermal characteristics of the real elements.
V. I. Kubov +2 more
exaly +2 more sources
APPLICATION OF PELTIER ELEMENTS AS RENEWABLE ENERGY SOURCES
EDULEARN Proceedings, 2022The growing use of renewable energy sources in many segments of life is an unavoidable topic of today's teaching, in particular, for students in the STEM field. For electrical engineering students, the focus is on the possibilities of producing electricity from renewable sources.
Dunja Srpak +3 more
openaire +2 more sources
Thermoregulation of Smart Clothing based on Peltier Elements
2020 IEEE East-West Design & Test Symposium (EWDTS), 2020The paper proposes a method of clothing creation that provides cooling (or heating) of the body based on a system of series-connected Peltier elements. The calculation of the power of heat loss for cooling the body as applied to smart clothing for the upper body, as well as the calculation of the power for cooling produced by the system of series ...
Mikhail F. Mitsik, Marina V. Byrdina
openaire +1 more source
One-dimensional modeling of a Peltier element
Proceedings ICT2001. 20 International Conference on Thermoelectrics (Cat. No.01TH8589), 2002For dimensioning and optimum control of Peltier coolers and heat pumps, an accurate numerical description of the performance parameters under various operation conditions is required. Here, the situation for homogeneous bismuth antimony telluride based Peltier cooler material is discussed, using representative values of constant material parameters in ...
Seifert, W. +4 more
openaire +3 more sources
Thermostat with Peltier element and microcontroller as a driver
Measurement, 2019Abstract The aim of this work was to construct a fast and precise thermostat that will operate without quasi-oscillatory processes during the temperature adjustment. The analysis of the temperature control process has shown that one of the possible solutions is pulsed driving in accordance with spontaneous temperature changes, which is an exponential
Predrag S. Iskrenović +4 more
openaire +1 more source
Operation of two stacked Peltier elements
Journal of Instrumentation, 2013Operation of a system built of two layers of identical Peltier elements is investigated. It is shown that adding the second layer increases the temperature difference between the cooled object and the heat sink much less than the factor 2 that could be naively anticipated.
openaire +1 more source
The development of low-temperature calorimeter on the Peltier elements
AIP Conference Proceedings, 2017The article is devoted to the design of low-temperature calorimeter on the Peltier elements. This calorimeter can be used to study the temperature dependence of the specific heat capacity of different substances.
Tatyana Baturevich, Anatoly Tyagunin
openaire +1 more source
Thermoelectric power generation: Peltier element versus thermoelectric generator
IECON 2016 - 42nd Annual Conference of the IEEE Industrial Electronics Society, 2016This paper presents a detailed comparison between Peltier elements (also called thermoelectric coolers (TEC)) and thermoelectric generators (TEG) for the usage as thermoelectric power generators. Whereas the former is normally known for cooling applications or heat pump uses, it can also be used as generator.
Marco Nesarajah, Georg Frey
openaire +2 more sources
Water Production System with Peltier Element and Photovoltaic Cell
2019 8th International Conference on Renewable Energy Research and Applications (ICRERA), 2019There are many areas in the world where clean drinking water cannot be provided stably. Therefore, it is important to provide water to such areas [1]. There are several methods to produce drinking water. For example, one way is to remove the salt or metal from sea water by distillation etc. [2]-[4].
Atsushi Nakajima, Shigeo Masukawa
openaire +1 more source