Results 101 to 110 of about 2,037,833 (341)
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
E3S Web of Conferences, 2018 The decrease in the ability of service of pavement can be caused by the durability factor in the pavement layer in receiving heavy traffic load and the temperature of the pavement.
Wahjuningsih Nurul +2 more
doaj +1 more source
Behaviour of pultruded beam-to-column joints using steel web cleats [PDF]
, 2013 Response of pultruded Fibre Reinforced Polymer (FRP) beam-to-column joints with steel bolted web cleats is studied through physical testing. Two joint configurations are considered with either three or two bolts per cleat leg, as per drawings in a ...
Bank +9 more
core +1 more source
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Resilient Modulus Characterization of Alaskan Granular Base Materials [PDF]
, 2010 INE/AUC 11 ...
Li, Lin, Liu, Juanyu, Zhang, Xiong
core
Ratcheting of granular materials [PDF]
, 2003 We investigate the quasi-static mechanical response of soils under cyclic loading using a discrete model of randomly generated convex polygons. This response exhibits a sequence of regimes, each one characterized by a linear accumulation of plastic ...
D. Kolymbas +4 more
core +2 more sources
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Irreversible thermodynamics of creep in crystalline solids
, 2013 We develop an irreversible thermodynamics framework for the description of creep deformation in crystalline solids by mechanisms that involve vacancy diffusion and lattice site generation and annihilation. The material undergoing the creep deformation is
Boettinger, W. J. +3 more
core +1 more source
Coseismic surface deformation from air photos: The Kickapoo step over in the 1992 Landers rupture [PDF]
, 2006 Coseismic deformation of the ground can be measured from aerial views taken before and after an earthquake. We chose the area of the Kickapoo-Landers step over along the 1992 Landers earthquake zone, using air photos (scale 1:40,000) scanned at 0.4 m ...
Avouac, Jean-Philippe, Michel, Rémi
core +1 more source
Advanced Engineering Materials, EarlyView.Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar +2 more
wiley +1 more source