Results 121 to 130 of about 291,572 (292)
Application of Raman and Photoluminescence Spectroscopy to MgO‐C Refractories
Advanced Engineering Materials, EarlyView.Visible to near infrared luminescence of MgO is studied on MgO‐C bricks and nominally pure MgO powder, with focus on two similar sharp high‐intensity signals, at 699 and 871 nm, each surrounded by symmetrical sidebands. The nature of these sidebands is investigated by temperature‐dependent spectroscopic measurements, confirming phonon involvement by ...
Julia Richter +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Geometry‐driven thermal behavior in wire‐arc additive manufacturing (WAAM) influences microstructural evolution during nonequilibrium solidification of a chemically complex Fe–Cr–Nb–W–Mo–C nanocomposite system. By comparing different deposits configurations, distinct entropy–cooling rate correlations, segregation, and carbide evolution are revealed ...
Blanca Palacios +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Thermomechanical fatigue tests of laser beam powder bed fusion (PBF‐LB) Inconel 718 show that the additively manufactured material reaches almost the lifetimes of conventionally‐rolled material under no‐dwell conditions. Introducing dwell times at the maximum temperature markedly reduces the lifetimes due to pronounced grain boundary sliding associated
Stefan Guth +6 more
wiley +1 more source
Nanoscale size effects in α-FAPbI3 evinced by large-scale ab initio simulations
Nature CommunicationsFormamidinium-lead-iodide (FAPbI3) has a rich phase diagram, and long-range correlation between the organic cations and lattice dipoles can influence phase transitions and optoelectronic properties.
Virginia Carnevali +5 more
doaj +1 more source
Pilot-aided modulation for narrow-band satellite communications [PDF]
This paper discusses a number of tone-aided modulation techniques which have been studied as part of the Mobile Satellite Experiment (MSAT-X) Program. In all instances tone(s) are inserted into data-free portions of the transmit spectrum and used by the ...
Rafferty, William, Saulnier, Gary J.
core +1 more source
Advanced Engineering Materials, EarlyView.Nickel‐based alloys are widely used in high‐temperature applications due to their excellent mechanical strength and oxidation resistance. However, properties such as high‐temperature strength and pronounced work‐hardening make them difficult to machine.
Soheil Rooein +2 more
wiley +1 more source
The model of ideal phase demodulator
Физика волновых процессов и радиотехнические системы, 2015 This paper presents a new approach for modeling transient process in complex linear passband systems with asymmetric amplitude frequency and phase characteristic that provides an ideal detection.
I.M. Lerner +2 more
doaj
Advanced Engineering Materials, EarlyView.Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Correcting angular distortions in Bragg coherent X-ray diffraction imaging
Journal of Synchrotron RadiationBragg coherent X-ray diffraction imaging (BCDI) has emerged as a powerful technique for strain imaging and morphology reconstruction of nanometre-scale crystals.
Huaiyu Chen +6 more
doaj +1 more source