Results 1 to 10 of about 56 (54)
Journal of Advanced Mechanical Design, Systems, and ManufacturingAiming at the sensitivity of installation errors caused by the complete conjugated tooth surface of cycloidal bevel gear, a method of tooth surface mismatch design which only modified the pinion cutter along two directions was proposed.
Shaowu NIE, Jinyu CHEN, Zhengyang HAN
doaj +4 more sources
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2020 In order to obtain locally conjugated tooth surface contact, a tooth surface mismatch modification method is proposed based on the fully conjugated characteristics of cycloidal bevel gear.
Jing DENG +3 more
doaj +1 more source
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2017 In order to solve the problem of the design and fabrication of high contact ratio spiral bevel gears with seventh-order transmission error (TE), an ease-off flank modification method is proposed based on the modified curvature motion method.
Yanming MU, Zongde FANG
doaj +1 more source
Modelling, design and analysis of offset, non-orthogonal and profile-shifted face gear drives
Advances in Mechanical Engineering, 2018 This article proposes the application of a profile-shifted grinding disc to generate an offset, non-orthogonal and profile-shifted face gear. A detailed investigation of the modelling, tooth geometry and contact characteristics of the offset, non ...
Xuezhong Fu +4 more
doaj +1 more source
Influence of Error Factors on Transmission Contact for Spiral Bevel Gears
Jixie chuandong, 2023 The full tooth flank contact characteristic of the line contact spiral bevel gear transmission is sensitive to errors. To obtain the influence of error factors on transmission contact for line contact spiral bevel gears, the contact simulation analysis ...
Wang Mingyang, Li Shuwen, Sun Yuehai
doaj
Research on noise reduction of drive axle hypoid gear based on tooth surface mismatch modification
Advances in Mechanical EngineeringIn order to reduce the transmission noise of drive axle hypoid gear, a method of tooth surface mismatch modification was proposed. Firstly, on the basis of establishing the grinding mathematical model of hypoid gear with cutter tilt, the theoretical ...
Shaowu Nie, Jinyu Chen, Shaohang Liu
doaj +1 more source
KEY TECHNOLOGY RESEARCH OF GEAR MACHINING ON HIGH BENDING LOAD CAPACITY
Jixie qiangdu, 2015 Dedendum fillet curve is an important factor that affects gear bending capacity and formed by tool conjugation.Consequently,it has great significance on improving bending capacity that the gear machining and top profile of gear cutter are researched ...
YU DongYang +4 more
doaj
Gear Cutting Machining of Klingelnberg Cyclo-palloid Bevel Gear based on Monolithic Cutter Disc
Jixie chuandong, 2018 In order to manufacture the Klingelnberg cyclo-palloid bevel gear on domestic CNC spiral bevel gear cutting machine,the processing method with monolithic cutter disc is researched. Based on the cutting principle of cyclo-palloid bevel gear,the processing
Wang Zhiyong +3 more
doaj
Jixie chuandong, 2014 The fourth order transmission error is applied to improve the transmission stability and tooth strength of circular-arc curvilinear of cylindrical gear.The coefficient of fourth order transmission error curve is determined,the curvilinear shaped ...
苏进展, 方宗德
doaj
The designing and modeling of equal base circle herringbone curved bevel gears. [PDF]
Sci Rep, 2023 Zhang R, Zhang B, Fu S.
europepmc +1 more source