Results 31 to 40 of about 251,382 (141)

Monier Pipe Factory, Burnley St, Richmond, Victoria

, 2021
This record was harvested from a previous catalogue system and will be withdrawn in 2025. Information in this record may be superseded or incomplete.
Reinforced Concrete and Monier Pipe Construction Co. Pty Ltd
core   +3 more sources

Crack Tracking in Small-Diameter Metal Pipe Using Controlled Motor Vibrations and Flexible Sensor

International Islamic University Malaysia Engineering Journal
Metal pipes are the most integral part of transporting water, gas, and other petrochemical substances over long distances. Higher strength, durability (along with wear and corrosion resistance), and lower cost make these pipes suitable for extreme ...
Md Rabiul Awal, Nurul Atiqah Tajulmar, Muhammad Syarifuddin Yahya, Nurafnida Afrizal, Wan Hafiza Wan Hassan, Nurul Adilah Abdul Latiff, Shakir Saat   +6 more
doaj   +1 more source

Microstructure-Based Lifetime Assessment of Austenitic Steel AISI 347 in View of Fatigue, Environmental Conditions and NDT

Applied Sciences, 2021
The assessment of metallic materials used in power plants’ piping represents a big challenge due to the thermal transients and the environmental conditions to which they are exposed.
Ruth Acosta, Klaus Heckmann, Jürgen Sievers, Tim Schopf, Tobias Bill, Peter Starke, Kai Donnerbauer, Lukas Lücker, Frank Walther, Christian Boller   +9 more
doaj   +1 more source

Ultrasonic guided wave testing on pipeline corrosion detection using torsional T(0,1) guided waves

Journal of Mechanical Engineering and Sciences, 2023
Ultrasonic guided wave testing is used in rapid screening to detect, locate and classify corrosion defects. This non-destructive testing technique can perform wide-range inspection from a single point, thus reducing the time and ...
C.Y. Teoh, J.S. Pang, M.N Abdul Hamid, L.E. Ooi, W.H. Tan   +4 more
doaj   +1 more source

Towards Automatic Robotic NDT Dense Mapping for Pipeline Integrity Inspection [PDF]

, 2022
This paper addresses automated mapping of the remaining wall thickness of metallic pipelines in the field by means of an inspection robot equipped with Non-Destructive Testing (NDT) sensing.
Behrens, M, Hunt, D, Miro, JV, Ulapane, N   +3 more
core   +1 more source

Unmanned Aerial Systems for Corrosion Detection: Multi‐Sensor Technologies, Challenges, and Opportunities for Next‐Generation Inspection

Quality and Reliability Engineering International, Volume 42, Issue 6, Page 3565-3583, October 2026.
ABSTRACT Corrosion remains a critical threat to the integrity and service life of infrastructure in industries such as oil, gas, construction, renewable energy, and transportation. Traditional inspection methods, being labor‐intensive, hazardous, and often subjective, fall short in addressing modern inspection demands.
Alhossein Alharbi, Yunes Alqudsi, Alhasan Ali Alharbi, Mohammed Basheer Mohiuddin   +3 more
wiley   +1 more source

Optical Fiber Sensors for Safety and Maintenance Monitoring of Linear Infrastructure

Advanced Sensor Research, Volume 5, Issue 5, May 2026.
This review rigorously provides a thorough and detailed overview of the most recent innovations and advancements in the field of railway and pipeline infrastructure monitoring, accomplished through the implementation of cutting‐edge fiber sensing technologies, with a specific emphasis on its two principal technical branches, namely multipoint sensing ...
Shengnan Wu, Yue Cao, Xiaokun Qian, Jianling Wu, Armando Laudati, Vincenzo Romano Marrazzo, Maria Alessandra Cutolo, Giovanni Breglio, Andrea Cusano, Antonello Cutolo, Sailing He   +10 more
wiley   +1 more source

Non‐Destructive Inspection of TCPs Using Pulse‐Echo Ultrasound and X‐Ray Microcomputed Tomography Techniques

X-Ray Spectrometry, Volume 55, Issue 3, Page 443-453, May/June 2026.
ABSTRACT Thermoplastic composite pipes (TCPs) have potential applications in offshore oil and gas industries because of their strength, lack of corrosion, and flexibility. Designed for fluid transportation in high‐pressure and high‐temperature environments, manufacturing defects and operational loads can compromise their performance.
Marcella Grosso Lima, Ighor B. C. de Paula, Raquel Marques Cautivo, Cesar Giron Camerini, Marysilvia F. da Costa, Hector G. Kotik, Celio A. Costa, Alessandra S. Machado, Davi F. Oliveira, Ricardo T. Lopes, Gabriela Ribeiro Pereira   +10 more
wiley   +1 more source

Dual‐Stage Heat Treatment for Enhanced Hydrogen Storage Properties of Mg−Ni−Y Alloys

Rare Metals, Volume 45, Issue 2, February 2026.
ABSTRACT Mg−Ni−Y alloy is considered to be one of the most promising hydrogen storage materials, but its high dehydrogenation energy barrier hinders its practical application. A dual‐stage heat treatment (490°C × 4 h + 550°C × 4 h) is applied to optimize the microstructure and hydrogen storage performance of a vacuum‐melted Mg94Ni3Y3 alloy.
You Lv, Qiang Yang, Jixing Zhu, Dongyue Zhao, Junyuan Fan, Valery Konstantinovich Sheleg, Xin Qiu   +6 more
wiley   +1 more source

Experimental and numerical investigation of repaired pipeline by composite sleeve using DIC technique and FEM

Journal of Pipeline Science and Engineering
This research investigates the impact of a composite laminate sleeve on a corroded pipeline during a hydrostatic test, adhering to the ISO-24817 & ASME PCC-2 standards, employing the Digital Image Correlation (DIC) technique.
MirMeysam Niksirat, Gholamhossein Rahimi, Shahram Hosseini, Gholamhossein Liaghat   +3 more
doaj   +1 more source