Results 81 to 90 of about 251,382 (141)
Reinforced Concrete Pipe factory, Richmond, Victoria
This record was harvested from a previous catalogue system and will be withdrawn in 2025. Information in this record may be superseded or incomplete.
Reinforced Concrete and Monier Pipe Construction Co. Pty Ltd
core
Fluid flow and heat transfer in a dual-wet micro heat pipe [PDF]
Micro heat pipes have been used to cool micro electronic devices, but their heat transfer coefficients are low compared with those of conventional heat pipes. In this work, a dual-wet pipe is proposed as a model to study heat transfer in micro heat pipes.
Watson, S.J., Wong, H., Zhang, J.
core +1 more source
Pipe organ air-coupled broad bandwidth transducer [PDF]
Air-coupled transducers are used to conduct fast non-contact inspections in NDT. Normally, the bandwidth of a conventional transducer can be enhanced, but with a cost to its sensitivity.
Mulholland, Anthony +12 more
core +1 more source
Test of reinforced concrete oviform pipe
This record was harvested from a previous catalogue system and will be withdrawn in 2025. Information in this record may be superseded or incomplete.
Reinforced Concrete and Monier Pipe Construction Co. Pty Ltd
core
Reinforced Concrete Pipe factory, Richmond, Victoria
This record was harvested from a previous catalogue system and will be withdrawn in 2025. Information in this record may be superseded or incomplete.
Reinforced Concrete and Monier Pipe Construction Co. Pty Ltd
core
Artificial neural network for the classification of steel hollow pipe [PDF]
Organized by School of Mechatronic Engineering (UniMAP) & co-organized by The Institution of Engineering Malaysia (IEM), 11th - 13th October 2009 at Batu Feringhi, Penang, Malaysia.Within industry, piping is a very important system that used to convey ...
Hafizawati, Zakaria +4 more
core
Abstract This paper presents the full implementation of a mobile robotic manipulator moving a probe inside steel cylinder concrete pipes (SCCP) for corrosion assessment. Mechanical prototype based on an off-the-shelf mobile base and a custom-designed manipulator, control and monitoring software architecture, posture control and ...
Larbi, Lucas Si +3 more
openaire +2 more sources
Numerical Analysis of Thermal Performance of Flat Heat Pipe [PDF]
Three dimensional numerical investigation is carried out to study the influence of geometry on thermal behavior of flat heat pipe. Two phase mixture model has been formulated to investigate the phase change phenomena during steady state operation of flat
Muthusamy, Kamaraj +2 more
core
Extended NDT for the quality assessment of adhesive bonded CFRP structures
10 S.Due to the increased use of carbon fibre reinforced plastics (CFRP) and the constant urge for lighter structures, adhesive bonding as an assembly technology has a great potential for high-loaded structures in the aeronautic industry.
Ehrhart, B. +5 more
core
Monier Pipe Factory, Burnley St, Richmond, Victoria
This record was harvested from a previous catalogue system and will be withdrawn in 2025. Information in this record may be superseded or incomplete.
Reinforced Concrete and Monier Pipe Construction Co. Pty Ltd
core

