Results 1 to 10 of about 3,213 (119)
To ensure the safety of research reactors, the water level must be maintained above the required height. When a pipe ruptures, the siphon phenomenon causes continuous loss of coolant until the hydraulic head is removed.
Soon Ho Kang +2 more
exaly +3 more sources
Fracture analysis for lubricating oil pipe of compressor [PDF]
The rupture analysis of lubricating oil pipe has been conducted through chemical composition analysis, metallographic analysis and fracture analysis. The analysis results show that there are machining defects and bidirectional vibration at the joint of ...
SI Jun, LV Huating, REN Facai
doaj +1 more source
The paper presents a cause-and-effect analysis of the failure of a 130 MWt gas-fired water boiler. The fault was a rupture of the helically finned tubes in the first rows of the second-stage water heater (ECO2).
Marcin Trojan +6 more
doaj +1 more source
Experiments and evaluation on residual strength of X52 steel pipe with various internal defects
The strength of the natural gas transmission pipe is reduced due to sag deformation and corrosion defects. However, there are rare experiment data to quantitatively describe the effect of the defect’s size and position on the pipe strength.
Changchao Qi +6 more
doaj +1 more source
Study on High Temperature Corrosion Performance of Biomass Boiler Superheater and Protective Measures [PDF]
Aiming at the problems of pressure - bearing pipes thinning and even rupture caused by the high temperature corrosion of the biomass boiler superheaters, the microstructure and properties of superheater tube wall after service were analyzed based on ...
ZHANG Pingheng, GONG Jun, JIN Jianrong, SUN Jian, ZHANG Hong, LI Dai, LIU Chengwei, LU Haifeng, CHEN Guoxing
doaj +1 more source
A 22-inch onshore natural gas transmission pipeline in operation since 1960 experienced an in-service rupture in January of 2018. The rupture was caused by an axial crack located 150 km (93 miles) downstream of the closest compression station.
Pablo Cazenave +4 more
doaj +1 more source
Reliability Analysis of Pipe Wall Thinning based on Quantification of Ultrasonic Testing
Piping in nuclear power plants is subject to corrosion and erosion caused by the interaction with fluids it carries. In order to prevent accidents such as pipe rupture, it is necessary to non-destructively inspect the thickness of the pipe wall and ...
Kantaro Ikeda +3 more
doaj +1 more source
REINFORCEMENT OF COMPOSITE PIPELINES FOR MULTIPURPOSE TRANSPORTATION [PDF]
The problem of monolithic behavior of a metal pipe and fiberglass safety cage has been considered in the article. The prestressed case does not only decrease the deformability of a pipe on-load but it also protects metal from corrosion.
Liudmyla TRYKOZ +3 more
doaj +1 more source
To assess the integrity of piping under the detonation pressure of accumulated hydrogen-oxygen, the fracture strain of the pipe material must be identified.
Akira NEBU +5 more
doaj +1 more source
Influence of axial load on internal pressure creep of Mod.9Cr-1Mo circumferential welded pipe
Mod.9Cr-1Mo steel(P91) is widely used for high temperature pipes in ultra-super-critical thermal power plants. However it was recently reported that the creep damage was detected at heat affected zone(HAZ) in welded joints of the pipes so-called the ...
Takashi OGATA +2 more
doaj +1 more source

