Results 81 to 90 of about 10,061 (256)
Measurement System for Non-Cylinder Pin Hole of Piston [PDF]
Aim to the low measuring precision of non-cylinder pin hole using the coordinate measuring machine(CMM)and pneumatic measuring instrument, a new solution is proposed which use the high-precision digital lever probe to detect the contours of pin hole with
F. Yang +4 more
core +1 more source
Biotinylation of a fluorescein‐based photosensitizer enhances its performance in PDT through a synergistic dual action. In addition to Type II singlet oxygen generation common to both dyes, the biotinylated system induces stronger membrane perturbation and higher local accumulation in lipid membranes, associated with increased water permeability and ...
Valeria Butera +4 more
wiley +1 more source
Experimental study on jet pulse assembly design and numerical simulation
Jet pulse assembly is one of the main components of jet hydraulic oscillator. The pressure wave characteristics produced by jet pulse assembly have an important influence on the performance of the tool.
Liang Xue +5 more
doaj +1 more source
Investigating the Cytoskeleton of DRGs Using Cryo‐Electron Microscopy and Deep Learning
ABSTRACT We describe a method for determining the ultrastructural organization of axons and varicosities of cultured dorsal root ganglion (DRG) neurons using cryogenic electron microscopy (cryo‐EM). Cryo‐EM reveals the dimensions, proximity, and overall organization of biological specimens in a near‐native state, avoiding artifacts of fixation and ...
M. Neal Waxham +3 more
wiley +1 more source
The fuel injection cycle-to-cycle variation characteristic in an opposed-piston compression ignition engine was investigated experimentally. Based on the optimal Proportion Integration Differentiation (PID) method, a new control method was proposed by ...
Yi Lu +4 more
doaj +1 more source
An assessment of stress and production rate of sucker rod heat pipes in oil well pumping system
The sucker rod pumping system is the preferred oil extraction technique. The concept about equipping the hollow vacuum space in solid sucker rods with heat pipe has been scrutinized in terms of stress and oil production evaluation. Abstract The implementation of the heat pipe concept in sucker rods for oil pumping systems negates the requirement for an
R. S. Anand +5 more
wiley +1 more source
This paper provides a fast method based on static reduction for the solution of the displacements of the piston ring's contact nodes. The nodal displacements and the corresponding nodal forces of the contact nodes are connected by the contact stiffness ...
Liu Yuwei, Li Heyan, Ye Fuhao
doaj
Micro-stabilised sightline for missile applications [PDF]
The feasibility of un-cooled long wave infrared (LWIR) imager line of sight (LOS) stabilization without the use of gimbals has been assessed with the aim of improving the existing performance of electro-optics (EO) sensors.
Smith, L.
core
Inspired by spiders, the multilegged walk‐through assembling robot for arc parts achieves high‐precision synchronous control under heavy loads through dual‐layer hydraulic pose dynamics modeling and hierarchical pressure optimization, significantly enhancing shield tunneling assembly efficiency and precision.
Quan Xiao +5 more
wiley +1 more source
Radial piston motors are executive components in hydraulic systems, tasked with providing appropriate torque and speed according to load requirements in practical applications.
Chunjin Li, Zhengwen Xia, Yongjie Tang
doaj +1 more source

