Results 121 to 130 of about 6,990 (261)
Earthquake Engineering &Structural Dynamics, EarlyView.ABSTRACT Seismic fragility assessment of reinforced concrete (RC) bridges exposed to corrosive environments must reliably capture time‐dependent deterioration impacts. Climate change compounds this challenge through nonstationary temperature and humidity variations that accelerate bridge corrosion.
Yexiang Yan, Yazhou Xie
wiley +1 more source
Time-Dependent Reliability Analysis of Reinforced Concrete Beams Subjected to Uniform and Pitting Corrosion and Brittle Fracture. [PDF]
Materials (Basel), 2021 Ben Seghier MEA, Keshtegar B, Mahmoud H.
europepmc +1 more source
Time‐Variant Seismic Fragility of Reinforced Concrete Bridge Piers Considering Degradation Phenomena
Earthquake Engineering &Structural Dynamics, EarlyView.ABSTRACT Aging and environmental exposure progressively deteriorate the physical and mechanical properties of construction materials, thereby affecting the safety and functionality of existing infrastructure. Corrosion of steel rebars in reinforced concrete structures is widely acknowledged as the most common and detrimental degradation phenomenon, as ...
Paolo Andrea Miglietta +4 more
wiley +1 more source
Automated ex-situ detection of pitting corrosion and its effect on the mechanical integrity of rare earth magnesium alloy - WE43. [PDF]
Bioact Mater, 2022 van Gaalen K +5 more
europepmc +1 more source
Materials and Corrosion, EarlyView.The localized corrosion behavior of lean duplex stainless steel EN 1.4062 is systematically compared with austenitic and higher‐alloyed duplex grades in natural seawater. A clear resistance ranking is established, highlighting EN 1.4062 as a cost‐effective alternative for limited marine exposure.
Mohammad Hassanzadeh +4 more
wiley +1 more source
Materials and Corrosion, EarlyView.Hybrid SiOₓ‐CVD/PDMS ultrathin films mitigate atmospheric corrosion of additively manufactured AlSi10Mg. Electrochemical analyses show reduced corrosion currents, increased charge‐transfer resistance, and suppressed pitting due to diminished cathodic activity and limited oxygen and ion transport under NaCl exposure.
Tim Prüßner +3 more
wiley +1 more source
Materials and Corrosion, EarlyView.This article examines the impact of externally introduced chromium compounds on the localized corrosion of 316 L stainless steel in acidic chloride environments such as hydrochloric acid. While the corrosion resistance of 316 L relies on the formation of a chromium‐rich passive oxide layer, industrial conditions may expose the steel to various chromium
Florence Lequien
wiley +1 more source
Assessment of Electrical Resistance Sensors Sensitivity to Localized Corrosion
Materials and Corrosion, EarlyView.Are electrical resistance (ER) sensors reliable for localized corrosion detection? This study combines analytical modeling and experimental validation to show the vulnerability of ER sensors. The results demonstrate significant underestimation of the true corrosion depth of localized attacks depending on defect's geometry.
Matěj Reiser, Milan Kouřil
wiley +1 more source
Susceptibility to Pitting Corrosion of AerMet 100 and 4340 Alloys for Aeronautical Applications. [PDF]
Materials (Basel)Huerta-Zavala MS +11 more
europepmc +1 more source
Materials and Corrosion, EarlyView.Schematic representation of the operando ICP‐OES setup during the electrochemical experiment (left). Resulting plot showing the dissolution of the individual alloy components of AA7075 as a function of applied potential in 10 mM NaCl (right). ABSTRACT This publication deals with the simultaneous acquisition of electrochemical and inductively coupled ...
Claudia Kutzer‐Schulze +2 more
wiley +1 more source