Results 151 to 160 of about 40,975 (295)
Pitting Corrosion Behavior and Surface Microstructure of Copper Strips When Rolled with Oil-in-Water Emulsions. [PDF]
Materials (Basel), 2021 Yan X, Sun J.
europepmc +1 more source
Sol‐Gel Coating on CA‐60 Steel Surfaces: A Process for Corrosion Inhibition
Materials and Corrosion, EarlyView.30% of the steel produced worldwide is used to replace losses due to corrosion. The application of the sol‐gel process to inhibit and delay deterioration appears as a viable methodology for protection against aggressive environments. ABSTRACT The phenomenon of corrosion causes worldwide damage, which is not only economic but also results in the loss of
Aguinaldo Manoel da Silva Junior +7 more
wiley +1 more source
Materials and Corrosion, EarlyView.The corrosion performance of X12CrMoWVNbN10‐1‐1 steel in chloride environments dramatically depends on pH. Acidic conditions trigger intense surface degradation, whereas neutral and alkaline media foster the formation of a compact and stable passive film, drastically reducing both general and localized corrosion.
Jovanka Pejić +5 more
wiley +1 more source
Influence of H<sub>2</sub>S on the pitting corrosion of 316L stainless steel in oilfield brine. [PDF]
Corros Sci, 2021 Hesketh J +4 more
europepmc +1 more source
Alloy Solutions for Ammonia Cracking: A Review
Materials and Corrosion, EarlyView.This work provides a literature overview of the nitriding and degradation of structural materials under ammonia cracking conditions and explains the known mechanisms and the gaps, where research is required. ABSTRACT Hydrogen is a key factor in energy storage and transportation, which will inevitably lead to a substantial increase in demand.
Mathias Christian Galetz +3 more
wiley +1 more source
Nano Select, EarlyView.The environmental behavior and impact of anti‐corrosion nanoadditives, ZnAl‐NO2 and MgAl‐NO2 layered double hydroxides (LDH), are assessed under marine conditions. These nanomaterials show instability in water but exhibit no or low toxicity to most tested marine species.
Joana Figueiredo +12 more
wiley +1 more source
Time-Dependent Reliability Analysis of Reinforced Concrete Beams Subjected to Uniform and Pitting Corrosion and Brittle Fracture. [PDF]
Materials (Basel), 2021 Ben Seghier MEA, Keshtegar B, Mahmoud H.
europepmc +1 more source
Nano Select, EarlyView.A novel magnetized Lippia javanica biosorbent is synthesized for efficient, simultaneous removal of Cu(II), Pb(II), and Zn(II) from water. This sustainable material exhibits high adsorption capacity, rapid magnetic separation, and excellent reusability over multiple cycles, demonstrating great potential for practical water purification applications ...
Philisiwe Nganaki Kunene +1 more
wiley +1 more source
Automated ex-situ detection of pitting corrosion and its effect on the mechanical integrity of rare earth magnesium alloy - WE43. [PDF]
Bioact Mater, 2022 van Gaalen K +5 more
europepmc +1 more source
Polymer Composites, EarlyView.Comparison of experimental and model‐predicted erosion rates for carbon fibre‐reinforced polymer (CFRP) and glass fibre‐reinforced polymer (GFRP) under low‐velocity (2 m/s) and at varying angles and sand concentrations (0.0, 0.05, 0.4 g/L). The results demonstrate good agreement between experimental data and model predictions across different erosive ...
Ali Al‐Darraji +4 more
wiley +1 more source