Results 21 to 30 of about 131,113 (167)
Experimental characterization of the edge fluctuations during I-phase at ASDEX Upgrade
The intermediate phase (I-phase) is a plasma regime that exists at the transition from the low-confinement mode (L-mode) to the fully developed high-confinement mode (H-mode), or vice versa.
J. Kalis +8 more
doaj +1 more source
Edge plasma measurements on the OP 1.2a divertor plasmas at W7-X using the combined probe
During its second operational campaign (OP 1.2a) W7-X operated with an edge island divertor. Much higher densities (1020m−3) than in to the previous, limiter campaign were achieved.
P. Drews +34 more
doaj +1 more source
The quasi-continuous exhaust regime in JET
The quasi-continuous exhaust (QCE) regime is a regime that is naturally type-I ELM-free. It combines the high density at the plasma edge needed for power exhaust with the high normalised energy confinement typical for H-mode operation.
M. Faitsch +19 more
doaj +1 more source
Plasma edge modelling with ICRF coupling
The physics of Radio-Frequency (RF) wave heating in the Ion Cyclotron Range of Frequencies (ICRF) in the core plasmas of fusion devices are relatively well understood while those in the Scrape-Off Layer (SOL) remain still unresolved.
Zhang Wei +11 more
doaj +1 more source
Comparison of divertor seed impurity gases retention efficiency by SOLPS-ITER modeling
In the paper a SOLPS-ITER modeling of H-Mode scenarios with different seed impurity gases (N, Ne, Ar, Kr) is performed for ASDEX Upgrade geometry. These gases are compared from the point of view of their radiation efficiency and compression in the ...
I.Yu. Senichenkov +5 more
doaj +1 more source
To study the transport of Li species in the plasma with real-time Li aerosol injection on EAST, a model has been developed by reducing Braginskii's equations, and implemented in the frame of BOUT++.
N.M. Li +7 more
doaj +1 more source
Influence of the Active Screen on the Embrittlement of a Plasma-Nitrided Edge [PDF]
In plasma nitriding of cutting tools, edge embrittlement can result from both, deepest layer, and grain boundaries precipitation. Overheating and surface charge density concentration in Direct Current Plasma Nitrided (DCPN) can be reduced through an ...
Júlio Azambuja da Silveira +3 more
doaj +1 more source
Edge radial electric field in positive and negative triangularity plasmas in the TCV tokamak
We present the first edge E _r measurements in negative triangularity (NT) plasmas in the Tokamak à Configuration Variable (TCV). The Doppler backscattering measurements of $v_\perp \approx E_r/B$ reveal a significant impact of triangularity on the E _r ...
S. Rienäcker +12 more
doaj +1 more source
Theory of edge plasma in a spheromak [PDF]
Abstract Properties of the edge plasma in the SSPX spheromak during the plasma formation and sustainment phases are discussed. For the breakdown and formation phase, the main emphasis is on the analysis of possible plasma contamination by impurities from the electrodes of the plasma gun (helicity injector).
E.B Hooper, R.H Cohen, D.D Ryutov
openaire +1 more source
Doubling fusion power with volumetric optimization in magnetic confinement fusion devices
A technique, volumetric power optimization, is presented for enhancing the power output of magnetic confinement fusion devices. Applied to a tokamak, this approach involves shifting the burning plasma region to a larger plasma volume while introducing ...
J. F. Parisi +19 more
doaj +1 more source

