Results 61 to 70 of about 219,317 (297)

The effect of external surface properties on the thermal behaviour of a transparently insulated wall [PDF]

, 2007
The properties of transparent plaster covering transparent insulation materials (TIM) were investigated using a whole building simulation program (ESP-r).
Heim, Dariusz, Klemm, Piotr, Strachan, Paul   +2 more
core  

Numerical and experimental study on P‐wave propagation across a rock joint with different orientations

Deep Underground Science and Engineering, EarlyView.
Joint orientation significantly affects P‐wave velocity, with the highest velocity at zero‐degree angles, decreasing to 30° as the angle increases. The velocity increases slightly from 30 to 45 degrees but sharply decreases from 45 to 90 degrees. Abstract Determination of the required parameters in different science contexts using the ultrasonic wave ...
Yaghoob Zarei, Mojtaba D. fallahi, Ali Uromeihy, Mohammad R. Nikoodel, Mohammad Fathollahy   +4 more
wiley   +1 more source

Internal stress wave measurements in solids subjected to lithotripter pulses [PDF]

, 1993
Semiconductor strain gauges were used to measure the internal strain along the axes of spherical and disk plaster specimens when subjected to lithotripter shock pulses. The pulses were produced by one of two lithotripters.
Burns, S. J., Dahake, G., Ding, Z., Everbach, E. Carr, Gracewski, S. M.   +4 more
core   +3 more sources

Seismic analysis and design of tunnels within fault ground: A review

Deep Underground Science and Engineering, EarlyView.
The research methods of seismic response of tunnels within fault ground, including field investigations, analytical solutions, physical experiments, and numerical simulations, and seismic countermeasures are discussed. The present study examines the shortcomings and limitations of the current research and design, and puts forward proposals for future ...
Xingda Wang, Yujing Jiang, Xuepeng Zhang, Yuyong Jiao, Ningbo Li, Xiao Wang, Bo Li   +6 more
wiley   +1 more source

The Effect of Silica Nanoparticles and nanodye on the Acoustic Absorption Rate of Nano-Composite Based on Hydrolyzed Cotton and Gypsum

طب کار, 2018
Introduction: Exposure to noise pollution in the workplace is one of the most common occupational hazards and causes hearing loss. One of the ways to control voice in the control industry is by audio absorbers.
, , , ,
doaj  

Recent Advances in Pickering Emulsion Templated Phase Change Material Microcapsules: Design, Fabrication, and Multifunctional Applications

ENERGY &ENVIRONMENTAL MATERIALS, EarlyView.
Fabrication process of phase change microcapsules using a Pickering emulsion template method and their subsequent applications. The increasing demand for efficient thermal energy storage systems has driven the development of phase change material microcapsules (PCMMs), which provide high energy‐storage density, reversible phase change, and reduced ...
Ziyan Li, Jinsheng Sun, Kaihe Lv, Chaozheng Liu, Meichun Li   +4 more
wiley   +1 more source

Archaeometric Investigation of Artificial Stone Materials from the Theatrum Marcelli (Rome, Italy)

Heritage
This study illustrates the results of minero-petrographic and microchemical investigations of artificial stone materials (mortars, plasters, and bricks) taken from the Theatrum Marcelli (Rome, Italy).
Maria Aantonietta Zicarelli, Michela Ricca, Maria Francesca Alberghina, Salvatore Schiavone, Mauro Francesco La Russa, Luciana Randazzo   +5 more
doaj   +1 more source

The Baptist Church in Warren: Rehabilitation and Preservation Report [PDF]

, 2013
The Baptist Church in Warren is located in the Warren Waterfront Historic National Register District. Warren also has a Voluntary Historic District. Both the National Register Nomination and the Voluntary Historic District have regulations which pertain ...
Bambara, Lauren, Cardarelli, Elizabeth, Kari, Valtinen, Pacheco, Corey, Robinson, Arnold   +4 more
core   +1 more source

3D‐Printed Models in Oral Surgery Simulation Training: A Scoping Review

Journal of Dental Education, EarlyView.
ABSTRACT Background Advancements in three‐dimensional (3D) printing have introduced innovative tools for medical and dental education. In dental surgery, 3D‐printed simulation models offer valuable presurgical training. This review explores the scope, study types, key findings, limitations, and future research needs to enhance their application in ...
Shahrzad Rahimizadeh Nahavandi, Leila Gholami, Amir Parham Pirhadi Rad, Morteza Ghojazadeh, Kevin Aminzadeh, Rana Tarzemany   +5 more
wiley   +1 more source

Evaluating the Effectiveness of 3D‐Printed Models in Tooth Morphology Training for Students

Journal of Dental Education, EarlyView.
ABSTRACT Purpose/Objectives Tooth morphology is a fundamental aspect of dental education, essential for various clinical disciplines. Traditional teaching methods, such as 2D visualizations, gypsum models, and wax or soap carving, have been widely used to develop students’ spatial understanding and manual skills.
Ivet Dzhondrova, Ilia Liondev, Hristina Galeva, Todor Bogdanov, Todor Uzunov, Dimitar Kirov   +5 more
wiley   +1 more source