Correction: Context-Dependent Plastic Response during Egg-Laying in a Widespread Newt Species. [PDF]
Tóth Z.
europepmc +1 more source
Graphene nanoplatelet (0.1 wt.%) reinforcement significantly enhances the performance of β Ti‐28Nb‐35.4Zr alloy. Grain refinement, reduced water contact angle, and improved surface characteristics promote osteoblast adhesion and complete surface coverage after 7 days.
Khurram Munir +5 more
wiley +1 more source
Cathodic Cage Plasma Deposition of Nanostructured Cu–Fe–Se Coatings on Poly(methyl Methacrylate)
Nanostructured Cu–Fe–Se coatings are deposited on PMMA by a modified cathodic cage plasma process, enabling low‐temperature deposition on polymer substrates. A transition from discontinuous to compact morphology is observed with temperature, with optimal properties at 200°C, where improved CuFeSe2‐type bonding, lowest sheet resistance, and favorable ...
V. S. S. Sobrinho +8 more
wiley +1 more source
Performance Characterization of a Plastic Scintillator Sensor for Fast Neutron, Thermal Neutron, and Gamma Ray Discrimination. [PDF]
Liu Y +6 more
europepmc +1 more source
Coarse‐grained (left) and atomistic (right) models of the shape memory polymer ESTANE ETE 75DT3 are shown schematically. The two representations bridge molecular detail and mesoscopic description. Both models capture shape memory behavior, linking segmental mobility and conformational relaxation of anisotropic chains to macroscopic recovery, and ...
Fathollah Varnik
wiley +1 more source
Concrete Damaged Plasticity-Based Analysis of Damage and Stiffness Degradation in Cooling Tower Shells Under Spatially Variable Seismic Loading. [PDF]
Boroń P, Dulińska JM.
europepmc +1 more source
This study shows that superalloys used in aircraft engine disks become much more prone to deformation at high temperatures if they have been strained during manufacturing. This effect increases with the level of prior strain but eventually reaches a limit.
Fabio Machado Alves da Fonseca +9 more
wiley +1 more source
Research on Bi-Objective Optimization of Injection Molding Process and Mechanical Anisotropy of Glass Fiber-Reinforced Polypropylene Fan Face Shell Based on RSM and NSGA-II. [PDF]
Yang M, Yan S, Liu J, Li F, Yao J, Li Y.
europepmc +1 more source
Composite Ti–6Al–4V–epoxy lattice structures are additively manufactured and epoxy infiltrated for cyclic loading. At low lattice volume fractions, hybridization produces synergistic gains in stiffness and energy dissipation. At higher volume fractions, synergy diminishes, although composites still exceed metallic lattices in specific energy ...
Joey Tallon +3 more
wiley +1 more source
Coupled experimental and numerical parametric study of projectile penetration into granular sandy soils under low-velocity impact. [PDF]
Osman AK +3 more
europepmc +1 more source

