Results 81 to 90 of about 6,919 (240)

Manipulating drying‐induced carbon nanotube assemblies through substrate surface engineering

Droplet, EarlyView.
During the observation of CNT droplet drying on modified substrates with varying surface properties, high‐friction surfaces induced long‐range orientation of CNTs through fixed contact lines and material flow during evaporation. This provides a programmable substrate strategy for assembling ordered nanostructures via controlled droplet drying ...
Ke Shui, Deng Pan, Tongtong Qin, Wenxin Xiao, Xin Li, Hao Yang, Jian Lin, Qingguang Xie, Jens Harting, Song Qiu, Chang‐Qi Ma   +10 more
wiley   +1 more source

Lithium Metal Anode Fabrication: Methods, Challenges, and Strategies

EcoEnergy, EarlyView.
Schematic illustration of four representative fabrication techniques for thin lithium metal anodes: extrusion, molten lithium infusion, electroplating, and physical vapor deposition (PVD). ABSTRACT The pursuit of ultra‐high energy‐dense lithium‐metal batteries (LMBs) has reignited the drive to fabricate ultrathin high‐quality lithium metal anodes. This
Ji Hyun Baek, Mi Ji Kang, Ho Won Jang
wiley   +1 more source

Local Buckling Analysis of Innovative Corrugated Profile of Soil-Steel Composite Bridges

The Baltic Journal of Road and Bridge Engineering
Corrugated soil-steel composite bridges due to their out-of-plane stiffness and interaction with surrounding soil are extensively used in the underground engineering.
Nerijus Bareikis, Algirdas Juozapaitis, Ilze Paeglīte   +2 more
doaj   +1 more source

Shaking Table Tests and Numerical Analysis of Rocking Vault‐Shaped Segmental Piers Equipped With an Annular Double Sliding System

Earthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT To enhance the structural robustness of bridges, a rocking arch‐shaped segmental pier with a double sliding system was previously proposed as a low‐cost solution to protect bridges in developing countries. The rocking behavior is triggered by halting the sliding motion, which increases the horizontal load‐bearing capacity and limits ...
Shengming Feng, Mitsuyoshi Akiyama, Shintaro Kobayashi, Ryosuke Kato, Elisa Vitolo, Hirokazu Takahashi, Shun Arima   +6 more
wiley   +1 more source

Full‐scale Shaking Table Tests on a 10‐story Steel Moment‐resisting Frame Building with Buckling‐restrained Braces

Earthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT In February 2023, a comprehensive series of shaking table tests were conducted at the E‐Defense facility, the world's largest three‐dimensional earthquake simulator, on a full‐scale 10‐story steel moment‐resisting frame supplemented with BRBs.
Jun Fujiwara, Jialiang Jin, Jionghui Li, Tianhao Yan, Ryota Nishi, Akiko Kishida, Koichi Kajiwara, Takuya Nagae, Taichiro Okazaki, Tatsuya Asai   +9 more
wiley   +1 more source

Concept, Tests, and Optimum Design of Novel Negative Stiffness Friction Dampers for Seismic Protection of Long‐Span Bridges

Earthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT Viscous dampers (VDs) are widely used to mitigate the excessive responses of long‐span bridges. However, VDs face some intricate challenges in engineering practices, including high damping coefficient requirement, potential base shear amplification and tremendous damping force under high velocity. To address these issues, this study develops a
Ruisheng Ma, Shaodong Jiang, Kun Xu, Qiang Han, Xiuli Du, Kaiming Bi   +5 more
wiley   +1 more source

Applied Element Modelling of Out‐Of‐Plane Instability in Boundary Elements of Thin RC Walls

Earthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT Recent earthquakes in Chile (2010) and New Zealand (2011) caused extensive damage to buildings featuring reinforced concrete (RC) structural walls, with observed failure modes including out‐of‐plane instability of slender walls. This buckling‐type response under combined in‐plane and out‐of‐plane loading has also been documented in ...
Andrea Orgnoni, Rui Pinho, João Pacheco de Almeida   +2 more
wiley   +1 more source

Effect of Ammonium Polyphosphate/Silicate Content on the Postfire Mechanics of Epoxy Glass‐Fiber Composites Using Facile Chocolate Bar‐Inspired Structures

Fire and Materials, Volume 49, Issue 3, Page 329-346, April 2025.
ABSTRACT This study investigates the postfire mechanical properties of epoxy glass‐fiber reinforced composites (EP GFRCs) using increasing concentrations of ammonium polyphosphate (APP) and inorganic silicate (InSi) to modify the char and fire residue.
Sruthi Sunder, Maria Jauregui Rozo, Sneha Inasu, Dietmar Meinel, Bernhard Schartel, Holger Ruckdäschel   +5 more
wiley   +1 more source

Estimating Elastic Buckling Load for an Axially Loaded Column Bolted to a Simply Supported Plate using Energy Method

مجلة النهرين للعلوم الهندسية, 2017
This paper deals with the elastic stability of a column bolted at its mid-height to a simply supported square plate and subjected to a concentrated load, using energy method. A uniform homogeneous column is assumed to be pinned at both ends.
Mustafa Kamal Al-Kamal
doaj  

Mechanical Behaviour of Vacuum‐Infused GFRP Composites at Elevated Temperatures—Influence of Fibre Architecture

Fire and Materials, EarlyView.
ABSTRACT This study addresses the influence of fibre architecture on the mechanical properties of vacuum‐infused glass fibre reinforced polymer (GFRP) composites at elevated temperatures (ET). Laminates with three different fibre configurations—unidirectional (UD), bidirectional 0°/90° cross‐ply (BD), and ±45° off‐axis angle‐ply (OA) – were tested in ...
Eloísa Castilho, João P. Firmo, Mário Garrido, João R. Correia, Afonso Ataíde   +4 more
wiley   +1 more source