Results 11 to 20 of about 697 (185)
Diyala Journal of Engineering Sciences, 2022 The goal of structural design is to select member sizes that are proportional to the structural geometry in order to achieve the most cost-effective design. Steel girders were typically made of webs, flanges and a number of internal stuffeners, the main
Usamah M. Salih +3 more
doaj +1 more source
PARAMETRIC STUDY OF THE LATERAL-TORSIONAL BUCKLING BEHAVIOR FOR STEEL GIRDERS WITH CORRUGATED WEBS [PDF]
The Egyptian International Journal of Engineering Sciences and Technology, 2022 The steel plate girder with the corrugated web is widely used in many applications because it has many advantages. It has a high resistance against lateral-torsion buckling compared with another flat web girder with the same steel weight.
Alia Abd El-Aziz, Fattouh F. Shaker
doaj +1 more source
Improving the Strength of Steel Perforated Plate Girders Loaded in Shear Using CFRP laminates [PDF]
Engineering and Technology Journal, 2015 The structural behavior of perforated composite web plate girders under shear loading is studied. Five steel plate girders have been tested. Two of them are reference girders, not perforated and perforated.
May J. Hamoodi +2 more
doaj +1 more source
Applied Sciences, 2020 The shear buckling of web plates and lateral–torsional buckling are among the major failure modes of plate girders. The importance of the lateral–torsional buckling capacity of plate girders was further evidenced when several plate girders of a bridge in
Celal Cakiroglu +3 more
doaj +1 more source
Civil and Environmental Engineering, 2022 Corrugated steel-plate girders are used as structural elements in many applications because of their properties, cutouts are always provided in these plate elements to enable inspection and servicing.
Tohamy A. S. +4 more
doaj +1 more source
Effect of Web Opening on the Ultimate Capacity of Steel Plate Girders under Two Points Load [PDF]
Engineering and Technology Journal, 2016 The structural behavior of steel plate girders with web opening is investigated in this study. An experimental and theoretical investigation of plate girders with circle and square openings in the web was conducted. The experimental work included testing
Mazin A. Al-Mazini
doaj +1 more source
Behavior of Steel Plate Girders with Web Openings Loaded in Shear [PDF]
Engineering and Technology Journal, 2013 The structural behavior of three steel plate girders under shear is studied. The first one is the reference plate girder (G) which is prepared without web openings, and the second one (GO) is fabricated to contain circular opening at the center of each ...
May J. Hamoodi, Marwa S. Abdul Gabar
doaj +1 more source
Metals, 2023 High-stiffener-web combined opening girders used on passenger ships are prone to plastic hinge failures around the opening area and overall instability under combined and vertical loads, exhibiting complex buckling behaviors.
Chen Chen +4 more
doaj +1 more source
INFLUENCE OF GEOMETRICAL AND STRUCTURAL IMERFECTIONS OF STEEL PLATE GIRDERS
Facta Universitatis. Series: Architecture and Civil Engineering, 2021 The girders or parts of the girders are not ideally flat in terms of their geometry. The deviations that occur are defined as geometric imperfections.
Dragana Turnić +4 more
doaj +1 more source
Analysis of the flexural performance of Precast Box Girders Reinforced with a combination of Steel-Slab-Concrete Plus Unbonded Prestressing [PDF]
E3S Web of Conferences, 2023 Due to the serious development of cracks in precast box girders, there is no reliable method to detect the loss of prestress and carry out effective reinforcement of box girders.
Xu Jun, Ma ZhiRong, Wu XiaoGuang
doaj +1 more source