Results 101 to 110 of about 370 (173)

Influence of spark gap in EDM based on Buckingham’s π theorem

, 2013
This project aims to highlight the importance of spark gap in EDM and Powder Mixed Dielectric EDM (PMEDM) in relations to surface roughness. Two output, spark gap and surface roughness were examined through Buckingham’s π theorem, a form of Dimensional ...
Toh, Jyh Yong.
core  

Multi-Channel Electrical Discharge Machining of Ti-6Al-4V Enabled by Semiconductor Potential Differences. [PDF]

Micromachines (Basel)
Zhu X, Wei T, Li S, Li G, Ding S.
europepmc   +1 more source

Current Research Trends on Dry, Near-Dry and Powder Mixed Electrical Discharge Machining

, 2011
Electrical discharge machining (EDM) technique has been widely used in modern metal working industry for producing complex cavities in dies and moulds, which are otherwise difficult to create by conventional machining.
K., Kadirgama, M. M., Noor, M. M., Rahman   +2 more
core  

Process optimization in micro electrical discharge machining of carbon kevlar hybrid composite using TOPSIS. [PDF]

Sci Rep
Dutta H, Debnath K, Karunanithi S, Vimala AA, Veeman D, Choudhury MR.   +5 more
europepmc   +1 more source

Parametric optimization of graphite powder-mixed electrical discharge machining of Ni-Cr dental alloy by response surface methodology. [PDF]

Sci Rep
San ES, Özerkan HB, Subaşı M, Ayhan E, Mavi A, Salunkhe S, Nasr ESA, Čep R.   +7 more
europepmc   +1 more source

The Effects of Reduced Graphene Oxide Flakes in the Dielectric on Electrical Discharge Machining. [PDF]

Nanomaterials (Basel), 2019
Świercz R, Oniszczuk-Świercz D.
europepmc   +1 more source

Performance optimization of wire EDM of Nitinol shape memory alloy using BBD RSM and TLBO with alumina nano graphene and MWCNT Powder mixed dielectric. [PDF]

Sci Rep
Rehman IU, Chaudhari R, Vora J, Patel V, Khanna S, Bhat SK.   +5 more
europepmc   +1 more source

Methods and variables in Electrical discharge machining of titanium alloy - A review. [PDF]

Heliyon, 2020
Pramanik A, Basak AK, Littlefair G, Debnath S, Prakash C, Singh MA, Marla D, Singh RK.   +7 more
europepmc   +1 more source

Taguchi optimization of Wire EDM process parameters for machining LM5 aluminium alloy. [PDF]

PLoS One
Juliyana SJ, Prakash JU, Čep R, Rubi CS, Salunkhe S, Sadhana AD, Nasr EA.   +6 more
europepmc   +1 more source

Intelligent optimization of micro-electrical discharge machining of aluminum nitride ceramics using nano abrasive zirconium oxide-enhanced biodegradable dielectric. [PDF]

Sci Rep
Ravi M, Thangavel G, Raja M, Sakthivel TG, Ashok N, Bhowmik A.   +5 more
europepmc   +1 more source