Results 181 to 190 of about 23,969 (212)
Some of the next articles are maybe not open access.
Generalized predictive control of PMSM
2013 25th Chinese Control and Decision Conference (CCDC), 2013This paper introduces a nonlinear control scheme based on linearized state space representation of the nonlinear Permanent Magnet Synchronous Motor (PMSM) model and predictive concept to control the PMSM. A comprehensive and detailed description of the design process of a Generalized Predictive Control (GPC) design and implementation with Hildreth's ...
Jiayu Yang, Peng Zhang, Xiangjie Liu
openaire +1 more source
Initial Position Detection of PMSM
2018 IEEE 9th International Symposium on Sensorless Control for Electrical Drives (SLED), 2018The paper deals with an initial and low speed rotor position estimation of Permanent Magnet Synchronous Motor (PMSM). A high frequency (hf) signal injection is used to excite the position dependent motor saliencies. Tracking those saliencies lead to the information about the rotor position.
Simon Zossak +3 more
openaire +1 more source
Introduction of PMSM Control Methods
2019Vector control is based on the rotor flux orientation. Torque control of the PMSM can be achieved by controlling the stator current vector. Using vector control method, the PMSM can obtain the same satisfactory control performance as the DC motor. Nowadays, vector control method has been widely used in the high-performance motor drives.
Gaolin Wang, Guoqiang Zhang, Dianguo Xu
openaire +1 more source
Comparison of Radial Flux PMSM and Axial Flux PMSM for Hybrid Electric Tracked Vehicles
2021Permanent magnet synchronous motors are increasingly becoming predominant with the upscale competitiveness of high-power permanent magnets. Permanent magnets are comparatively more efficient because the field excitation losses are extinguished that leads to significant rotor loss minimization. Thus, the motor efficiency is greatly surpassed, and higher
S. T. Vigneshwar, N. C. Lenin
openaire +1 more source
Nonlinear torque control for PMSM
Melecon 2010 - 2010 15th IEEE Mediterranean Electrotechnical Conference, 2010This study presents a novel means of designing a simple and effective torque control for Permanent Magnet Synchronous Motor (PMSM). The overall stability of the system is shown using Lyapunov technique. The Lyapunov functions used contain a term penalizing incremental energy of control error, torque and stator flux, enhancing the stability.
openaire +1 more source
Output feedback control of PMSM
49th IEEE Conference on Decision and Control (CDC), 2010The problem of controlling a Permanent Magnet Synchronous Motor is approached in this paper eliminating the necessity of including a speed sensor and without knowledge of the (constant) load torque. The proposed controller is obtained by equipping a well-known state-feedback scheme with an observer for estimating the speed and an adaptation law for the
Loria, Antonio, Espinosa-Pérez, G.
openaire +2 more sources
PMSM Noise - Simulation Measurement Comparison
SAE Technical Paper Series, 2018<div class="section abstract"><div class="htmlview paragraph">Growing development of hybrid and fully electrical drives increases demand for accurate prediction of noise and vibration characteristic of electric and electronic components. This paper describes the numerical and experimental investigation of noise emission from PMSM electric ...
Borislav Klarin +5 more
openaire +1 more source
Field‐weakening in high‐performance PMSM drives
COMPEL - The international journal for computation and mathematics in electrical and electronic engineering, 2002The comparative analysis of field‐weakening (FW) in vector controlled and DTC permanent magnet synchronous motor drives is performed. The results of simulations and a comprehensive set of experiments are also given. The possibility of unstable operation in the high‐speed region using DTC is emphasised.
ZORDAN M. +5 more
openaire +1 more source
High performance control of PMSM
2010 First Symposium on Sensorless Control for Electrical Drives, 2010This paper proposed a new switching scheme for controlling permanent magnet synchronous motor (PMSM). The voltage source inverter (VSI) is represented as event driven system with 23 modes of operation. The switching among these modes is governed by the supervisory control approach.
K. Jezernik, R. Horvat
openaire +1 more source
Simple speed observer for PMSM
2017 9th International Congress on Ultra Modern Telecommunications and Control Systems and Workshops (ICUMT), 2017This paper is devoted to design and investigation of simple speed observer for non-salient permanent magnet synchronous motors. The key feature of this observer is that it requires the knowledge the motor resistance and inductance and can be applied in situations when viscous friction coefficient and load torque are known.
Alexey Bobtsov +4 more
openaire +1 more source