Results 11 to 20 of about 4,349,462 (261)
Influence of Electrodes Polarization on the Response of Resistive Soot Sensor
Procedia Engineering, 2016 Abstract This study reports on the influence of the polarization applied between platinum electrodes of a resistive soot sensor. The conductance measured between these electrodes represents the sensor response which increases during soot deposition over time at fixed parameters (soot flow, polarization).
Grondin, D. +4 more
openaire +2 more sources
Polarization properties of interferometrically interrogated fiber Bragg grating and tandem-interferometer strain sensors [PDF]
, 2006 Lead sensitivity in low-coherence interferometric fiber-optic sensors is a well-known problem. It can lead to a severe degradation in the sensor resolution and accuracy through its effect on the fringe visibility and interferometric phase.
Flockhart, G M H +2 more
core +4 more sources
Angular and polarization response of multimode sensors with resistive-grid absorbers [PDF]
Journal of the Optical Society of America A, 2014 22 pages, 15 ...
Kusaka, Akito +2 more
openaire +3 more sources
International Journal of Electrochemical Science, 2018 Corrosion condition of steel in concrete under drying/wetting exposure to chloride ion solution was monitored based on various electrochemical techniques including linear polarization (LP), electrochemical impedance spectra (EIS) and half-cell potential (
Ming Jin +7 more
doaj +1 more source
Sensors and Actuators B: Chemical, 2019 Abstract Resistive soot sensors capable of measuring the mass concentration of particles in an exhaust pipe have been developed in a previous work. In particular, it has been shown that these sensors have an optimal sensitivity for a certain polarization voltage depending on the nature of the particles.
Grondin, Didier +3 more
openaire +2 more sources
Efficient fiber Bragg grating and fiber Fabry-Pe'rot sensor multiplexing scheme using a broadband pulsed mode-locked laser [PDF]
, 2005 A pulsed broadband mode-locked laser (MLL) combined with interferometric interrogation is shown to yield an efficient means of multiplexing a large number of fiber Bragg grating (FBG) or fiber Fabry-Perot (FFP) strain sensors with high performance ...
Flockhart, G M H +2 more
core +4 more sources
A Study on Double Inputs Direct Contact and Single Output Capacitively Coupled Conductivity Detector
Sensors, 2022 In this paper, an improved double inputs direct contact and single output capacitively coupled conductivity detector (DISODCD) based on traditional contactless capacitively coupled conductivity detector (C4D) is developed.
Shuangfei Zhang, Hongyan Yuan, Dan Xiao
doaj +1 more source
Sensors, 2016 In this paper, a new kind of carbon steel (CS) and stainless steel (SS) galvanic sensor system was developed for the study of rebar corrosion in different pore solution conditions.
Yunze Xu +5 more
doaj +1 more source
Sensors, 2013 The corrosion of reinforcements induced by chloride has resulted to be one of the most frequent causes of their premature damage. Most corrosion sensors were designed to monitor corrosion state in concrete, such as Anode-Ladder-System and Corrowatch ...
Weiliang Jin, Zhiyuan Li, Chen Xu
doaj +1 more source
Optimization of the electrical signal generation of a microbial fuel cell for sensor applications
Vietnam Journal of Science, Technology and Engineering, 2022 In previous studies, a microbial fuel cell (MFC) was developed as a potential sensor that detects iron in water. However, to realize such an application in practice, the electrical signal generation of the MFC must be improved. Therefore, in this study,
Duan Dong Ta +2 more
doaj +1 more source