Results 41 to 50 of about 253 (134)
Advanced Sustainable Systems, Volume 10, Issue 3, March 2026.This study analyses the uncertainty and variability existing in the economic performance of polylactic acid (PLA) production, via integrating techno‐economic analysis with process models and Monte Carlo simulation enabled by artificial intelligence. The results show that the minimum selling price varies from $2,107 to $3076/t PLA.
Yinqiao Wang +5 more
wiley +1 more source
Advanced Science, Volume 13, Issue 15, 13 March 2026.Magnesium silicide (Mg2Si) is introduced as a narrow‐bandgap, biodegradable semiconductor for transient electronics. RF‐sputtered and annealed Mg2Si thin films show high intrinsic electrical conductivity and low thermal conductivity. The polycrystalline material undergoes hydrolysis in aquatic and composting environments with minimal cytotoxicity ...
Ji‐Woo Gu +17 more
wiley +1 more source
Advanced Science, Volume 13, Issue 13, 3 March 2026.A resonant frequency engineering strategy is proposed to modulate the sensibility of piezoresistive textile‐based tactile sensor. It achieves simultaneous detection of static pressure and dynamic vibrations across an unprecedented bandwidth of 5–600 Hz, surpassing human sensation, therefore enables rapid and precise braille recognition.
Xianhong Zheng +17 more
wiley +1 more source
Increasing the succinate yield in Actinobacillus succinogenes by fumigation of H2 in a bioreactor
Biofuels, Bioproducts and Biorefining, Volume 20, Issue 2, Page 591-605, March/April 2026.Abstract The microbial conversion of CO2 into value‐added chemicals offers a promising and scalable route for sustainable bioproduction, particularly under mild reaction conditions and with technically straightforward reactor configurations. Actinobacillus succinogenes, a natural succinate producer, can fix CO2 through anaplerotic carboxylation but its
Julian Tix +3 more
wiley +1 more source
Chinese Journal of Polymer Science, 2018 In this work, the crystallization of immiscible polypropylene (PP)/polybutene-1 (PB) blends, in particular the effect of crystal morphology of PP (HTC, high Tm component) on the subsequent crystallization behavior of PB (LTC, low Tm component) was studied.
Yao Xu +3 more
openaire +2 more sources
Journal of Chemical Technology &Biotechnology, Volume 101, Issue 3, Page 477-493, March 2026.Abstract This article presents a comprehensive examination of agricultural production, biomass generation, and its transformation into biochar, with a particular emphasis on green coconut waste as a primary resource. It underscores the link between agriculture and substantial biomass output, shedding light on the ecological issues associated with solid
Yslaine Andrade de Almeida +4 more
wiley +1 more source
Polímeros, 2013 Neste trabalho investigou-se o efeito de poliisobutenos (PIB´s), de massas molares variando de 480 a 1.600 g/mol, no polipropileno isotático. Composições contendo até 7% dos PIB´s foram preparadas em misturador interno e corpos de prova foram ...
Uédson Alexandre do Nascimento +2 more
doaj
Microstructure and Tensile Properties of Melt-Spun Filaments of Polybutene-1 and Butene-1/Ethylene Copolymer. [PDF]
Polymers (Basel), 2023 Li J +11 more
europepmc +1 more source
Attapulgite Structure Reset to Accelerate the Crystal Transformation of Isotactic Polybutene. [PDF]
Polymers (Basel), 2022 Mao SD +9 more
europepmc +1 more source