Results 81 to 90 of about 366 (156)
Numerical Investigation into Dynamic Fracture of PCBN
, 2011 Polycrystalline Cubic Boron Nitride (PCBN) is a super-hard material, which is used in some of the most demanding material removal operations today. PCBN cutting tools are employed in turning of hardened steels as well as machining of other abrasive and ...
Alojz Ivanković +2 more
core +1 more source
Polycrystalline cubic boron nitride (PcBN) is a super-hard material with a multiphase composite character. As it is the case for other super hard materials, information on the smallscale response of PcBN is rather scarce.
Todeschini, Antoine
core
Self-Sharpening Abrasive Composite Bulks with PCBN Grains
, 2011 Abrasive composite bulks consisting of polycrystalline cubic boron nitride (PCBN) grains, Cu-Sn-Ti alloy and graphite particles were sintered at the heating temperature of 920 °C for the dwell time of 30 min.
B. Zhang +4 more
core +1 more source
Analiza topografii i nośności powierzchni po obróbce na twardo przy użyciu narzędzi z PCBN
, 2014 This paper deals with hard turning using conventional and wiper polycrystalline cubic boron nitride (PCBN) tools. 3D surface topographies and bearing area curves were determined and compared after hard turning with differently shaped cutting tools ...
Żak, K., Smardziova, M.
core +1 more source
Research on Cutting Layer Characteristics of Superalloy under High-Pressure Cooling. [PDF]
Materials (Basel), 2023 Li L, Chen S, Li T, Wu M.
europepmc +1 more source
Performance assessment of pCBN and bCBN tools in machining of high-chromium white cast iron
, 2015 This paper presents an experimental evaluation of the performance of cubic boron nitride (CBN) tools in the machining of high-chromium white cast iron.
Zhou, Jinming +4 more
core +1 more source
The Influence of Surface Texturing of Ceramic and Superhard Cutting Tools on the Machining Process-A Review. [PDF]
Materials (Basel), 2022 Grigoriev SN +11 more
europepmc +1 more source
, 2005 Cutting experiments and finite element analysis (FEA) using ANSYS software have been carried out in this paper in order to investigate the effects of chamfer angle on the cutting forces and the cutting tool stresses, principal and von Mises stress, of ...
KURT, ABDULLAH, Seker, ULVİ
core +1 more source
In Situ TEM and AFM for Investigation of Materials. [PDF]
Materials (Basel), 2021 Lamberti L.
europepmc +1 more source
Laser Processing of Hard and Ultra-Hard Materials for Micro-Machining and Surface Engineering Applications. [PDF]
Micromachines (Basel), 2021 Hazzan KE, Pacella M, See TL.
europepmc +1 more source