Results 21 to 30 of about 4,289,395 (298)
A GIS-Based Multidimensional Evaluation Method for Solar Energy Potential in Shanxi Province, China
Energies, 2023 Solar energy is considered one of the most hopeful alternative sources to avoiding dependence on fossil fuels, and it does not cause any air pollution. GIS-based solar energy potential evaluation is mainly focused on regional scale; further, more solar ...
Liang Cui +3 more
doaj +1 more source
An analytical method for quantifying the flexibility potential of decentralised energy systems [PDF]
Applied Energy, 2023 In this study, we developed a technology-independent method for quantifying the time-varying flexibility potential of different energy systems. As the flexibility of these systems was assumed to be an additional service, their primary application must not be undermined by flexibility provision; for example, providing flexibility from a heat pump must ...
Maitanova, Nailya +3 more
openaire +1 more source
Comparison of determination methods of vibration’s damping coefficients for complex structures
Budownictwo i Architektura, 2008 The purpose of this paper is to present methods of vibrations damping coefficient determination. The methods, such as collocation method, two energetic methods and half-power bandwidth method concern composite structures.
Andrzej Flaga +2 more
doaj +1 more source
Yantu gongcheng xuebao, 2021 Based on the improved minimum potential energy algorithm, a new method for the stability analysis of horizontal-vertical (H-V) ribs-reinforced slopes is proposed. In this method, the frictional potential energy of horizontal reinforcement, linear elastic
JIANG Jian-guo , CHEN Yuan , LIU Sun-guang , ZHAO Fa-jia
doaj +1 more source
Machines, 2021 Tool temperature variation in flank milling usually causes excessive tool wear, shortens tool life, and reduces machining accuracy. The heat source is the primary factor of the machine thermal error in the process of cutting components.
Yunxia Guo, Wenhua Ye, Xiang Xu
doaj +1 more source
Transient stability analysis using potential energy indices for determining critical generator sets [PDF]
, 2014 In this paper, we propose the enhancement of existing power system stability analysis techniques through the use of a proposed set of potential energy indices, applied for observing the separation of generators into critical sets during transient events.
Alamuti, MM, Saunders, CS, Taylor, GA
core +1 more source
Gradients of the polarization energy in the effective fragment potential method
The Journal of Chemical Physics, 2006 The effective fragment potential (EFP) method is an ab initio based polarizable classical method in which the intermolecular interaction parameters are obtained from preparative ab initio calculations on isolated molecules. The polarization energy in the EFP method is modeled with asymmetric anisotropic dipole polarizability tensors located at the ...
Li, Hui, Netzloff, Heather, Gordon, Mark
openaire +4 more sources
Research on the Influence of Backlash on Mesh Stiffness and the Nonlinear Dynamics of Spur Gears
Applied Sciences, 2019 In light of ignoring the effect of backlash on mesh stiffness in existing gear dynamic theory, a precise profile equation was established based on the generating processing principle. An improved potential energy method was proposed to calculate the mesh
Yangshou Xiong +5 more
doaj +1 more source
Animals, 2021 The inclusion of orange pulp (OP) in pig diets may promote the circular economy, but drying procedures might influence its nutritional value and environmental impact.
Pablo Ferrer +6 more
doaj +1 more source
Applied Sciences, 2022 Volume loss is an important method to estimate ground movement during tunnelling. However, volume loss is usually estimated by empirical methods, especially for volume loss at the tunnel face, which is a three-dimensional problem.
Gan Wang +4 more
doaj +1 more source