Results 61 to 70 of about 405,494 (225)
Materials and Corrosion, EarlyView.Climate‐neutral green hydrogen is produced via water electrolysis using renewable energy. This study explores using cold gas spraying to apply titanium coatings on steel bipolar plates for proton exchange membrane water electrolyzers. The coating shows effective corrosion protection, presenting a promising solution for future designs.
Kirsten Bobzin +3 more
wiley +1 more source
Potentiodynamic polarization curves of 420SS in 1M H2SO4/5% TC solutions.
, 2018 Potentiodynamic polarization curves of 420SS in 1M H2SO4/5% TC solutions.
Roland Tolulope Loto (4888771)
core +1 more source
Materials and Corrosion, EarlyView.Corrosion inhibitors CuSO4 and NaVO3 achieved up to 98% inhibition efficiency for carbon steel S275 in CO2‐loaded MEA solvent, reducing corrosion rates to 9.4 µm/year—outperforming costly stainless steel SS 316 L at a fraction of the cost. ABSTRACT Corrosion in CO2 capture units significantly impacts safety and costs.
Eleni Lamprou +6 more
wiley +1 more source
Potentiodynamic polarization curves of 420SS in 1M H2SO4/4% TC solutions.
, 2018 Potentiodynamic polarization curves of 420SS in 1M H2SO4/4% TC solutions.
Roland Tolulope Loto (4888771)
core +1 more source
Ocimum basilicum L. Oil as Corrosion Inhibitor for Aluminium in Hydrochloric Acid Solution
International Journal of Electrochemical Science, 2013 Ethanol solution of Ocimum basilicum L. oil was studied as corrosion inhibitor for aluminium in 0.5 M HCl. Its inhibition effect was performed using weight loss measurements, potentiodynamic polarization and EIS methods.
Jasna Halambek +2 more
doaj +1 more source
Potentiodynamic Polarization Behaviour of Electroless Ni-P-W Coatings [PDF]
ISRN Corrosion, 2012 This paper deals with the synthesis of electroless Ni-P-W coatings on mild steel substrate followed by furnace-annealing process. Corrosion behaviors of the coatings after heat treatments at various annealing temperatures are evaluated by potentiodynamic polarization test using 3.5% sodium chloride solution.
Supriyo Roy, Prasanta Sahoo
openaire +1 more source
Analysis of Corrosion and Wall Perforation in the Heat Exchanger Made of AISI 316L Stainless Steel
Materials and Corrosion, EarlyView.Elevated passivation temperature is identified as the dominant factor triggering localized corrosion and subsequent perforation of AISI 316L heat exchanger tubes. Electrochemical and complementary characterization results show that the alloy retains high resistance to general, pitting, and intergranular corrosion, indicating that failure primarily ...
Bojana Radojković +7 more
wiley +1 more source
Potentiodynamic polarization curves of 420SS in 1M H2SO4/1%—3% TC solutions.
, 2018 Potentiodynamic polarization curves of 420SS in 1M H2SO4/1%—3% TC solutions.
Roland Tolulope Loto (4888771)
core +1 more source
International Journal of Electrochemical Science, 2014 Three oligopolymers derived from a-Naphthol (N), formaldehyde (F) with aniline (TERP-1), paraaminobenzoic acid (TERP-2) and sulphanilic acid (TER-3) were synthesized and their inhibitive action on corrosion of mid steel in 1M HCl was studied using ...
Chandra Bhan Verma +2 more
doaj +1 more source
Fretting Wear and Corrosion Behavior of the Fe‐35Mn Biodegradable Alloy for Biomedical Applications
Materials and Corrosion, EarlyView.This study evaluates the corrosion and tribological wear behavior of the Fe‐35Mn alloy, demonstrating superior mechanical stability and a more favorable degradation rate than pure iron, thereby highlighting its potential for biomedical applications. ABSTRACT The biodegradable Fe‐35Mn alloy has emerged as a promising material for temporary implants due ...
Kerolene Barboza da Silva +7 more
wiley +1 more source