Results 11 to 20 of about 1,019,163 (292)
Powder co-injection moulding [PDF]
, 2000 A novel powder processing technique has been developed by combining conventional powder injection moulding with polymer co-injection moulding, to permit the in-situ surface engineering of metal or ceramic components as an integral step within the ...
Hanson, S. M. J.
core +7 more sources
The effect of powder recycling in direct metal laser deposition on powder and manufactured part characteristics [PDF]
, 2006 A potential way of improving the material efficiency and cost effectiveness of the Direct Metal Laser Deposition (DMLD) process is to take powder that is not utilised in each deposition attempt and re-use it in subsequent attempts (powder recycling ...
Scudamore, R. +8 more
core +4 more sources
Selective Laser Sintering of a Stainless Steel Powder [PDF]
, 2003 The research presented in this thesis was part of a larger collaborated project (LastForm Programme) to research engineering solutions for the rapid manufacture of large scale (0.5m – 5.0m in length) low, medium and high temperature tooling (from room ...
Hauser, Carl
core +6 more sources
Analysis of rheological behaviour of titanium feedstocks formulated with a water-soluble binder system for powder injection moulding [PDF]
, 2014 Binder selection and formulation are critical in powder injection moulding. Binders play a key role in controlling the rheological properties of a feedstock and influence whether the resulting feedstock can be successfully injection moulded, debound and ...
Pickering, Kim L. +3 more
core +1 more source
Pressure-free molding of powder-mesh materials [PDF]
MATEC Web of ConferencesThe process of forming powder-mesh materials (PMM) composed of a woven mesh of corrosion-resistant steel and electrolytic nickel powder without applying pressure using binders is considered.
Ilyushchanka Aliaksandr +5 more
doaj +1 more source
Microstructure and properties of C/C composites brazed with Ni-Cr-P pasty filler metal
Cailiao gongcheng, 2020 The Ni-Cr-P metal powder was prepared by vacuum melting and inert gas atomization method, and then an organic binder was added and stirred at high speed to prepare a Ni14Cr10P paste-like filler metal. The prepared pasty filler metal was used to braze the
YI Zhen-hua, RAN Li-ping, YI Mao-zhong
doaj +1 more source
Advanced Powder MaterialsHigh-energy density dielectrics for electrostatic capacitors are in urgent demand for advanced electronics and electrical power systems. Poly(vinylidene fluoride) (PVDF) based nanocomposites have attracted remarkable attention by intrinsic high ...
Ru Guo +8 more
doaj +1 more source
Physical and Magnetic Properties of ThMn12-Type Sm(Fe0.8Co0.2)10Si2 Melt-Spun Ribbons
Metals, 2022 The magnetic properties of ThMn12-type Fe-rich compounds were investigated by producing Sm(Fe0.8Co0.2)10Si2 ribbons. The produced ribbons, with different conditions by varying the melt-spinning conditions, were characterized to investigate physical and ...
Hui-Dong Qian +7 more
doaj +1 more source