Results 231 to 240 of about 49,283 (291)

3D printing: Balancing innovation for sustainability with emerging environmental and health risks. [PDF]

iScience
Alijagic A, Suljevic D, Engwall M, Särndahl E.   +3 more
europepmc   +1 more source

Potential Uses and Challenges of Three-dimensional Printing in Cardiothoracic Surgery in Africa - a Narrative Review. [PDF]

Braz J Cardiovasc Surg
Effiom VB, Biswas K, Chandran BVS, Mathari SE, Femi-Lawal V, Vinck E, Hirji SA.   +6 more
europepmc   +1 more source

The Influence of Model Orientation on the Surface Roughness of Polymeric Models Produced by FFF, mSLA, PJ, and SLS Methods. [PDF]

Materials (Basel)
Bazan A, Turek P, Budzik G, Niesłony P, Grygoruk R, Siemiński P.   +5 more
europepmc   +1 more source

High-throughput printing of functionally gradient material from self-propagation. [PDF]

Nat Commun
Zhang Y, Liu Y, Ren G, Yu C.
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Powder-bed 3D printing meets orthopedic rehabilitation devices

2021
Transactions on Additive Manufacturing Meets Medicine, Vol 3 No 1 (2021): Trans ...
Mehdipour, Fatemeh, Shirzadi Jahromi, Hassan   +1 more
openaire   +2 more sources

3D printing of clay paste enhanced by scrap polymer from powder bed processes

Rapid Prototyping Journal, 2021
Purpose Powder bed additive manufacturing processes are widespread due to their many technical and economic advantages. Nevertheless, the disposal of leftover powder poses a problem in terms of process sustainability. The purpose of this paper is to provide an alternative solution to recycle waste PA12 powder from HP multi jet fusion.
Mattia Mele, Michele Ricciarelli, Giampaolo Campana   +2 more
openaire   +2 more sources