Results 231 to 240 of about 6,405 (263)
Some of the next articles are maybe not open access.
Metal Powder Injection Molding of Microcomponents
2015AbstractThis article discusses the process details of metal powder injection molding of microcomponents and the powder particle characteristics of feedstock and property requirements of binders. It reviews important characteristics to be considered in the processing steps: venting, channel diameters, binder segregation, binder degradation, feedstock ...
openaire +1 more source
MOLD-FILLING SIMULATION FOR POWDER INJECTION MOLDING
Processing and Fabrication of Advanced Materials VIII, 2001X. Chen, Y.C. Lam, K.C. Tam, S.C.M. Yu
openaire +1 more source
SIMULATION OF MOLD FILLING IN POWDER INJECTION MOLDING
Materials Processing, 2006S. K. Samanta +5 more
openaire +1 more source
Introduction to Metal Powder Injection Molding
2015AbstractThis article describes part selection, feedstock (powders and binders) characteristics and properties, tool design, and material and tooling for fabrication of metal powder injection molding (MIM) machines. It discusses the process parameters, operation sequence, molding machines, debinding techniques, consolidation (sintering) techniques ...
openaire +1 more source
Molding properties of titanium-based feedstock used in low-pressure powder injection molding
Powder Technology, 2021Vincent Demers
exaly
Effect of powder loading on metal injection molding stainless steels
Journal of Materials Processing Technology, 2007Yimin Li
exaly