Results 11 to 20 of about 154,655 (285)

Harmonic-Reduced Bias Circuit for Ultrasound Transducers

open access: yesSensors, 2023
The gain of class-C power amplifiers is generally lower than that of class-A power amplifiers. Thus, higher-amplitude input voltage signals for class-C power amplifiers are required.
Hojong Choi
doaj   +1 more source

Systematization of a Multilevel-Topology-Based Linear Amplifier Family for Noiseless DC–AC Power Conversion

open access: yesIEEE Access, 2021
Electrical power converters use semiconductor switching devices for a larger loss reduction compared with non-switching power linear amplifiers, such as class-B amplifiers.
Hidemine Obara   +2 more
doaj   +1 more source

Mobile Phone Power Amplifier Linearity and Efficiency Enhancement Using Digital Predistortion [PDF]

open access: yes, 2003
The new generation mobile communication systems using spectrum efficient linear modulation schemes (QPSK,8PSK,QAM)need linear power amplifiers in the transmission path to have good ACPR and EVM values.
Ceylan, N.   +3 more
core   +1 more source

Development of a Class-C Power Amplifier with Diode Expander Architecture for Point-of-Care Ultrasound Systems

open access: yesMicromachines, 2019
Point-of-care ultrasound systems are widely used in ambulances and emergency rooms. However, the excessive heat generated from ultrasound transmitters has an impact on the implementation of piezoelectric transducer elements and on battery consumption ...
Hojong Choi
doaj   +1 more source

Industrial GaInP/GaAs Power HBT MMIC Process [PDF]

open access: yes, 2000
UMS has developed an industrial power HBT process especially dedicated to power MMICs in the 10GHz frequency range. The process has been qualified and meets the very demanding specifications required for X-Band high power amplifiers.
Auxemery, P.   +4 more
core   +1 more source

Theory Based on Device Current Clipping to Explain and Predict Performance Including Distortion of Power Amplifiers for Wireless Communication Systems [PDF]

open access: yes, 2008
Power amplifiers are critical components in wireless communication systems that need to have high efficiency, in order to conserve battery life and minimise heat generation, and at the same time low distortion, in order to prevent increase of bit ...
Tian, Yunjia, Tian, Yunjia
core   +1 more source

Suitability of acoustic power amplifiers as power amplifiers in underwater communication systems [PDF]

open access: yesInternational Journal of Electronics and Telecommunications
The paper presents selected acoustic power amplifiers from among those currently available. The results of a series of measurements characteris ing the amplifiers are presented.
Aleksander M. Schmidt   +2 more
doaj   +1 more source

A design methodology for audio amplifiers with no global negative feedback: proposal and validation

open access: yesSemina: Ciências Exatas e Tecnológicas, 2022
This paper proposes a structured methodology for the design of high-performance audio amplifiers without the use of global negative feedback. This type of amplifier is being suggested in order to minimize supposed deleterious effects on audio quality ...
Rafael Marchiori Visintin   +3 more
doaj   +1 more source

Filterless, Digital Class-BD Audio Amplifiers with Constant Common Mode Output Voltage

open access: yesEnergies, 2021
This paper presents new and original architectures and implementations of two filterless, open-loop digital Class-BD audio amplifiers with constant common mode (CM) output voltage.
Stanisław Kuta   +3 more
doaj   +1 more source

A 120 W Class-E Power Module with an Adaptive Power Combiner for a 6.78 MHz Wireless Power Transfer System

open access: yesEnergies, 2018
In this article, a highly efficient power module is presented with two class-E power amplifiers and an adaptive power combiner for transmitting output powers >100 W at 6.78 MHz in a wireless power transfer system.
Ui-Gyu Choi, Jong-Ryul Yang
doaj   +1 more source

Home - About - Disclaimer - Privacy