Results 101 to 110 of about 134,723 (348)

Packaging of RF Mems Switching Functions on Alumina Substrate [PDF]

open access: yes, 2006
Recently the strong demands in wireless communication requires expanding development for the application of RF MEMS (Radio Frequency micro electro mechanical systems) sensing devices such as micro-switches, tunable capacitors because it offers lower ...
Blondy, P.   +2 more
core   +2 more sources

Coordinated Multi‐Component Gradient Engineering of Catalyst Layers for Advanced Polymer Electrolyte Fuel Cells

open access: yesAdvanced Functional Materials, EarlyView.
This work presents a continuous linear gradient catalyst layer design, a general strategy for improving membrane electrode assemblies across electrochemical devices. Fabricated via a dual‐nozzle spray coating method, the architecture controls the Pt/carbon ratio, ionomer content and ionomer type across the catalyst layer, enhancing proton conduction ...
Shangwei Zhou   +15 more
wiley   +1 more source

Roll‐to‐Roll Mechanical Exfoliation for Large‐Area van der Waals Films with Preserved Crystallographic Alignment

open access: yesAdvanced Functional Materials, EarlyView.
A roll‐to‐roll exfoliation method is demonstrated that preserves the crystallographic alignment of anisotropic 2D materials over large areas, enabling scalable fabrication of directional electronic and optoelectronic devices. Abstract Anisotropic 2D materials such as black phosphorus (BP), GeS or CrSBr, exhibit direction‐dependent optical and ...
Esteban Zamora‐Amo   +14 more
wiley   +1 more source

Comparison between flying capacitor and modular multilevel inverter [PDF]

open access: yes, 2009
The paper describes the operational principle of flying capacitor and modular multilevel inverters. The detailed discussions of dc link capacitors voltage balancing methods for both inverters are given in order to enable fair comparison. The causes of dc
Adam, G.P.   +5 more
core  

Tuning the Electronic Structure and Spin State of Fe─N─C Catalysts Using an Axial Oxygen Ligand and Fe Clusters for High‐Efficiency Rechargeable Zinc–Air Batteries

open access: yesAdvanced Functional Materials, EarlyView.
A FeN4─O/Clu@NC‐0.1Ac catalyst containing atomically‐dispersed FeN4─O sites (medium‐spin Fe2+) and Fe clusters delivered a half‐wave potential of 0.89 V for ORR and an overpotential of 330 mV at 10 mA cm−2 for OER in 0.1 m KOH. When the catalyst was used in a rechargeable Zn–air battery, a power density of 284.5 mW cm−2 was achieved with excellent ...
Yongfang Zhou   +8 more
wiley   +1 more source

Discrete component S-band power amplifier [PDF]

open access: yes
A spacecraft S-band power amplifier for Nimbus satellite is reported that achieves stability by use of moderate Q input and output circuits. The discrete component amplifier uses distributed inductance and small piston capacitors for resonance and ...
Block, A. F.
core   +1 more source

Spectrally Tunable 2D Material‐Based Infrared Photodetectors for Intelligent Optoelectronics

open access: yesAdvanced Functional Materials, EarlyView.
Intelligent optoelectronics through spectral engineering of 2D material‐based infrared photodetectors. Abstract The evolution of intelligent optoelectronic systems is driven by artificial intelligence (AI). However, their practical realization hinges on the ability to dynamically capture and process optical signals across a broad infrared (IR) spectrum.
Junheon Ha   +18 more
wiley   +1 more source

Cascaded transformerless DC-DC voltage amplifier with optically isolated switching devices [PDF]

open access: yes, 1993
A very high voltage amplifier is provided in which plural cascaded banks of capacitors are switched by optically isolated control switches so as to be charged in parallel from the preceding stage or capacitor bank and to discharge in series to the ...
Sridharan, Govind
core   +1 more source

Trap‐Modified Inverted Organic Photodetectors via Layer‐by‐Layer Processing with Poly(N‐vinylcarbazole) Additives

open access: yesAdvanced Functional Materials, EarlyView.
Trap state engineering in inverted organic photodetectors (OPDs) is achieved via combined layer‐by‐layer (LbL) processing and poly(N‐vinylcarbazole) (PVK) incorporation. LbL reduces the trap density while PVK additives gradually shift trap states from shallow band‐edge to deep mid‐gap levels, tailoring the energy distribution.
Jingwei Yi   +10 more
wiley   +1 more source

Home - About - Disclaimer - Privacy