Results 11 to 20 of about 4,720,670 (304)

An integrated modelling and parameter design method for the RC snubber in novel cascode GaN‐based bridge convertors

open access: yesIET Power Electronics, 2022
The utilization of novel cascode GaN devices can significantly increase the power density and the efficiency of convertors. However, owing to high switching speed (high dv/dt or di/dt) and inevitable parasitic inductance in device packages and external ...
Bin Luo, Guangzhao Luo, Sihai Li
doaj   +1 more source

An interleaved high step‐down coupled inductor based quadratic DC‐DC converter

open access: yesIET Power Electronics, 2023
A high step‐down direct current‐direct current (DC‐DC) buck converter with a coupled‐inductor in its topology is presented in this study. The switching pattern of the proposed converter is interleaved; therefore, the voltage stress on the semiconductors ...
Reza Pashaie   +2 more
doaj   +1 more source

1996 Wholesale Power and Transmission Rate Schedules. [PDF]

open access: yes, 1996
Bonneville Power Administration`s (BPA) 1996 Wholesale Power Rate Schedules, 1996 Ancillary Products and Services Rate Schedule, 1996 Transmission Rate Schedules, and General Rate Schedule Provisions, contained herein, were approved on an interim basis ...
United States. Bonneville Power Administration.
core   +1 more source

A transformer‐less DC–DC converter with high voltage conversion ratio adopting inverting voltage lift cell

open access: yesIET Circuits, Devices and Systems, 2022
In this work, a high voltage gain dc‐dc converter is proposed based on a switched inductor cell. The proposed converter utilises an inverting switched capacitor cell at the output side to achieve high voltage gain. Extendibility of the proposed structure
Ebrahim Babaei   +2 more
doaj   +1 more source

Design and development of a cascaded modular multi‐level converter based on current‐fed quadruple‐active bridge converters for grid integration of photovoltaic systems

open access: yesIET Energy Systems Integration, 2021
This article proposes a new topology of a cascaded modular multi‐level converter (MMC) based on the current‐fed quadruple active bridge (CFQAB) converters for grid integration of photovoltaic (PV) systems.
Zahra Malekjamshidi, Mohammad Jafari
doaj   +1 more source

Living and Working Safely Around High-Voltage Power Lines. [PDF]

open access: yes, 1998
High-voltage transmission lines can be just as safe as the electrical wiring in the homes--or just as dangerous. The crucial factor is ourselves: they must learn to behave safely around them.
United States. Bonneville Power Administration.
core   +1 more source

A single‐source switched‐capacitor based 13‐level sextuple boost inverter with reduced component count and low THD

open access: yesIET Generation, Transmission & Distribution, 2023
A switched‐capacitor‐based 13‐level inverter with a lesser number of components is presented in this article. The 13‐level single‐phase AC output voltage is achieved with a voltage gain of 6 by including a single DC source, 11 switches, 4 capacitors, and
Md Reyaz Hussan   +5 more
doaj   +1 more source

Maturation of Dynamic Power Convertors for Radioisotope Power Systems [PDF]

open access: yes, 2019
Dynamic Radioisotope Power Systems (DRPS) are being developed by NASA's RPS Program in collaboration with the U.S. Department of Energy (DOE) for space science and exploration missions.
Oriti, Sal, Wilson, Scott
core   +2 more sources

A capacitor voltage self‐balancing method of modular multilevel converters based on switching state matrix construction

open access: yesIET Power Electronics, 2023
This study presents a submodule capacitor voltage self‐balancing method for modular multilevel converters (MMCs) based on switching state matrix construction, which has an advantage over eliminating massive sensor demanding and alleviating computational ...
Zhou Yiyuan   +7 more
doaj   +1 more source

Non‐isolated high step‐up DC–DC converter based on switched‐inductor switched‐capacitor network for photovoltaic application

open access: yesIET Generation, Transmission & Distribution, 2023
A high step‐up non‐isolated DC–DC converter based on a switched‐inductor/switched‐capacitor network is proposed in this paper. The proposed converter takes advantage of both active and passive switched inductor cells. Inductors L1 and L2 can be connected
Hossein Jalali Farahani   +2 more
doaj   +1 more source

Home - About - Disclaimer - Privacy