Results 21 to 30 of about 178,054 (300)
Superconducting fault current limiter application in a power-dense marine electrical system [PDF]
, 2011 Power-dense, low-voltage marine electrical systems have the potential for extremely high fault currents. Superconducting fault current limiters (SFCLs) have been of interest for many years and offer an effective method for reducing fault currents.
Blair, Steven Macpherson +5 more
core +1 more source
Fault Classification in Power Distribution System with Distributed Generation
International Journal of Advanced Research in Science, Communication and Technology, 2023 The primary aim of Power System is to provide uninterrupted power supply to consumers but the performance of Power System is frequently affected by Power Distribution System faults. In order to maintain the continuity of supply and to improve the efficiency of Power System the Power Distribution System fault should be rapidly diagnosed and treated ...
null Prof. P. S. Dorale +1 more
openaire +1 more source
DC-bus power quality for aircraft power systems during generator fault conditions [PDF]
IET Electrical Systems in Transportation, 2011 Higher-voltage, 540V, aircraft DC-bus power quality is examined experimentally and by computer simulation during a short-circuit fault across the phase terminals of a 70kW, five-phase, permanent magnet fault-tolerant generator. The DC-bus transients caused by the short-circuiting of the generator phases are seen to exceed the limits in MIL-STD-704F and
Todd, R., Forsyth, A. J.
openaire +2 more sources
Fault Detection and Classification in Interconnected System with Wind Generation Using ANN and SVM
Advances in Electrical and Electronic Engineering, 2022 Protective relays are installed in generation, transmission, and distribution system for detection, classification, and estimation of faults. To match the future load demand and to get uninterrupted power supply, use of renewable energy sources are ...
Hinal Shah +2 more
doaj +1 more source
Voltage sag assessment using an extended fault positions method and Monte Carlo simulation
Dyna, 2016 In this article, we propose an extended fault positions method combined with the Monte Carlo method to evaluate voltage sags. The distribution function SARFI is obtained by taking into account the randomness of (i) location of faults in lines, (ii ...
Jorge Washington Sagre +2 more
doaj +1 more source
Engineering Science and Technology, an International Journal, 2023 Series compensation is widely used to improve the electrical characteristics of long transmission lines and increase the power transfer capability. However, the insertion of a series capacitor introduces various phenomena that affect the performance of ...
Patrick T. Manditereza
doaj +1 more source
Preventive Control Strategy of Cascading Fault considering Safety and Economy
Journal of Electrical and Computer Engineering, 2021 The operation and structure of the power system are becoming increasingly complex, and the probability of cascading fault increases. To this end, this paper proposes a cascading fault preventive control strategy that considers safety and the economy ...
Hui-Qiong Deng +4 more
doaj +1 more source
Research on evaluation method of energy supply reliability of regional energy Internet [PDF]
E3S Web of Conferences, 2021 This paper studies the reliability evaluation technology of regional energy Internet and represents a reliability evaluation method considering the optimal load reduction strategy. The application scenario of regional Energy Internet with power system as
Li Pengli +4 more
doaj +1 more source
Topology assessment for 3 + 3 terminal offshore DC grid considering DC fault management [PDF]
, 2014 Peer ...
Jovcic, Dragan +3 more
core +1 more source
DC-bus power quality for UAV systems during generator fault conditions [PDF]
5th IET International Conference on Power Electronics, Machines and Drives (PEMD 2010), 2010 High-voltage DC-bus power quality is examined experimentally and by computer simulation during a short-circuit fault across the phase terminals of a five-phase, permanent magnet fault-tolerant generator. The DC-bus transients are seen to exceed the limits in MIL-STD-704F [1] and a control algorithm is proposed for a supercapacitor-based energy storage ...
Todd, R., Forsyth, A. J.
openaire +3 more sources