Results 41 to 50 of about 96,152 (211)
POSSIBILITY OF APPLICATION OF ACTIVE FILTERS HARMONIC IN 0.4 KV DISTRIBUTIVE NETWORKS
Вестник Северо-Кавказского федерального университета, 2022 DISTRIBUTIVE NETWORKS The work is devoted to the evaluation of one of the ways to improve the quality of electric power -the use ofparallel active harmonic filters in 0.4 kV distribution networks.
G. Kolesnikov, N. Shchikunov
doaj
Electric Power Loss Minimization in Power Supply Systems for the Suburban Houses [PDF]
Problems of the Regional Energetics, 2018 The main purpose of the research is the development and improvement of methods for minimizing power losses for non-sinusoidal and asymmetric modes of operation of power supply systems for suburban houses.
Averbukh М.А. +2 more
doaj +1 more source
Optimal passive filter design for effective utilization of cables and transformers under non-sinusoidal conditions [PDF]
, 2014 Transformers and cables have overheating and reduced loading capabilities under non-sinusoidal conditions due to the fact that their losses increases with not only rms value but also frequency of the load current.
Aleem, SHEA +3 more
core +1 more source
Ain Shams Engineering JournalThe rising usage of power electronic converters linked to renewable energy sources has become a major source of harmonics in power systems. Passive harmonic filters are an excellent solution for addressing this issue.
Asmaa Elhussiny +4 more
doaj +1 more source
Ain Shams Engineering Journal, 2023 Harmonic distortion levels in current power systems have increased due to technical advancements in industrial and renewable energy applications. So far, passive power filters have been widely employed to minimize harmonics and lessen their adverse ...
Ahmed M. Zobaa +2 more
doaj +1 more source
Power quality improvement using passive shunt filter, TCR and TSC combination [PDF]
, 2012 Power system harmonics are a menace to electric power systems with disastrous consequences. The line current harmonics cause increase in losses, instability, and also voltage distortion.
Badi, Manjulata
core
Dynamic Harmonic Distortion Analysis and Mitigation Strategies for DC Third Rail Systems
Urban Rail TransitHarmonic distortions in DC third rail systems can cause overheating of electric motors and transformers. Single-tuned filters and shunt active harmonic filters (SAHFs) are often used to mitigate the harmonic distortions.
Dick Sang Hoo +4 more
doaj +1 more source
A Hybrid Active Filter Using the Backstepping Controller for Harmonic Current Compensation [PDF]
, 2019 This document presents a new hybrid combination of filters using passive and active elements because of the generalization in the use of non-linear loads that generate harmonics directly affecting the symmetry of energy transmission systems that ...
Ababssi, Najib +3 more
core +1 more source
Optimal sizing of C-type passive filters under non-sinusoidal conditions [PDF]
, 2014 In the literature, much attention has been focused on power system harmonics. One of its important effects is degradation of the load power factor. In this article, a C-type filter is used for reducing harmonic distortion, improving system performance ...
Dugan R. C. +4 more
core +2 more sources
Discover ElectronicsThe present manuscript offers a detailed review of literature about the harmonic distortion causes and mitigation methods in modern electrical power systems.
Jagdeep Kaur, Sarbjeet Kaur Bath
doaj +1 more source