Results 91 to 100 of about 593,815 (289)
Advanced Engineering Materials, EarlyView.The wettability of aluminum droplets (Al) on different copper substrates (Cu), where liquid Al spreads on solid Cu surfaces to form a liquid–solid interface, is studied numerically and experimentally. The experimental and numerical results show good agreement in the fast‐spreading regime.
Shan Lyu +8 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Through direct application of porous transport layer (PTL) on the bipolar plate (BPP) with thermal spraying, the interfacial contact resistance is improved. With the cold gas sprayed BPP–PTL coating system, a proton exchange membrane water electrolysis cell with a cell voltage of Ucell = 1.9 V can be operated up to i = 2.5 A/cm2 in a dynamic mode ...
Kirsten Bobzin +5 more
wiley +1 more source
Power-over-Fiber LPIT for Voltage and Current Measurements in the Medium Voltage Distribution Networks. [PDF]
Sensors (Basel), 2021 Bassan FR +7 more
europepmc +1 more source
Advanced Engineering Materials, EarlyView.This paper presents a novel approach to reducing oxide layers on metal powders using low‐temperature hydrogen dielectric barrier discharge plasmas at atmospheric pressure. Unlike conventional hydrogen‐plasma reductions, the powders do not contact the plasma directly.
Shukang Zhang +3 more
wiley +1 more source
Results in Physics, 2018 We report on random lasing observed with 100-m-long fiber comprising an array of weak FBGs inscribed in the fiber core and uniformly distributed over the fiber length.
S.M. Popov +7 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study reports lightweight polyetherimide triply periodic minimal surfaces lattices coated with carbon nanotube‐reinforced epoxy that combine mechanical robustness with self‐sensing. The conformal coating enhances stiffness, strength and energy absorption while enabling reliable strain monitoring.
A. Triay +3 more
wiley +1 more source
Over 400 W average power, sub-two-cycle, carrier-envelope phase-stable fiber laser system
High Power Laser Science and EngineeringWe report on the development of a carrier-envelope phase (CEP)-stable 1030 nm fiber-based laser system producing 6.2 fs pulses achieved via the multi-pass cell (MPC) post-compression technique with 402 W average power at 100 kHz repetition rate.
Imre Seres +15 more
doaj +1 more source
Scientific Reports, 2020 We demonstrate a compact picosecond master-oscillator power-amplifier (MOPA) system based on an Yb-doped polarization-maintaining double-clad tapered fiber (T-DCF) delivering pulses with over 1.26 MW peak power and average output power up to 200 W ...
Andrey Petrov +5 more
doaj +1 more source
Surface Tension Measurement of Ti‐6Al‐4V by Falling Droplet Method in Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.In this article, the temperature‐dependent surface tension of free falling, oscillating Ti‐6Al‐4V droplets is investigated in both argon and monosilane doped, oxygen‐free atmosphere. Droplet temperature and oscillation are captured with one single high‐speed camera, and the surface tension is calculated with Rayleigh's formula.
Johannes May +9 more
wiley +1 more source
Demonstration of an In-Flight Entertainment System Using Power-over-Fiber
PhotonicsThe use of optical fibers is increasing in modern aircraft because this helps solve challenges of size, weight, communication, and reliability in new generation aircraft.
Joao B. Rosolem +4 more
doaj +1 more source