Results 121 to 130 of about 418,652 (294)

Computer-Aided Modeling and Analysis of Power Processing Systems (CAMAPPS), phase 1 [PDF]

The large-signal behaviors of a regulator depend largely on the type of power circuit topology and control. Thus, for maximum flexibility, it is best to develop models for each functional block a independent modules. A regulator can then be configured by
Cho, B. H., Kim, S., Lee, F. C., Lee, J.
core   +1 more source

Al–Cu Composite Casting of Laser‐Deoxidized Copper: Bonding, Interfacial Chemistry, and Thermal Conductivity

Advanced Engineering Materials, EarlyView.
This study investigates laser‐based oxide removal of Cu inserts in oxygen‐free conditions and examines long‐term oxidation kinetics and surface chemistry under different atmospheres via X‐ray photoelectron spectroscopy. Al–Cu compound casting with differently oxidized surfaces is performed, and intermetallic phase formation, morphology, and thermal ...
Timon Steinhoff, Finn‐Lennard Janthur, Sascha Zimmermann, Sarah Seffer, Jörg Hermsdorf, René Gustus, Ludger Overmeyer, Wolfgang Maus‐Friedrichs, Hans Jürgen Maier, Christian Klose   +9 more
wiley   +1 more source

Investigation of Oxygen‐Free Wetting Behavior of Aluminum on Copper via Molecular Dynamics Simulations and Experiments

Advanced Engineering Materials, EarlyView.
The wettability of aluminum droplets (Al) on different copper substrates (Cu), where liquid Al spreads on solid Cu surfaces to form a liquid–solid interface, is studied numerically and experimentally. The experimental and numerical results show good agreement in the fast‐spreading regime.
Shan Lyu, Timon Steinhoff, Finn‐Lennard Janthur, Sarah Seffer, Jörg Hermsdorf, Christian Klose, Ludger Overmeyer, Hans‐Jürgen Maier, Nina Merkert   +8 more
wiley   +1 more source

Transient Synchronization Stability Analysis of Parallel-Connected Grid-Forming Converters and Grid-Following Stations

IEEE Access
In novel power systems, complex coupling among stations and devices with diverse synchronization mechanisms profoundly impacts system stability.
Xinyu Guo, Junji Ma, Chao Fang, Leilei Shen, Yanbin Liu   +4 more
doaj   +1 more source

Dynamic Testing of Cold Gas Sprayed Bipolar Plates–Porous Transport Layer Coating System in Proton Exchange Membrane Water Electrolysis

Advanced Engineering Materials, EarlyView.
Through direct application of porous transport layer (PTL) on the bipolar plate (BPP) with thermal spraying, the interfacial contact resistance is improved. With the cold gas sprayed BPP–PTL coating system, a proton exchange membrane water electrolysis cell with a cell voltage of Ucell = 1.9 V can be operated up to i = 2.5 A/cm2 in a dynamic mode ...
Kirsten Bobzin, Marvin Erck, Kevin Jasutyn, Katja Radermacher, Andreas Bund, Mario Kurniawan   +5 more
wiley   +1 more source

Dynamic reactive power planning method for CSP-PV hybrid power generation system

Journal of Measurement Science and Instrumentation, 2020
Aiming at the faults of some weak nodes in the concentrated solar power-photovoltaic（CSP-PV） hybrid power generation system, it is impossible to restore the transient voltage only relying on the reactive power regulation capability of the system itself ...
ZHANG Hong, DONG Hai-ying, CHEN Zhao, HUANG Rong, DING Kun   +4 more
doaj  

Power system transient stability enhancement

, 2016
In this thesis the power system transient stability analysis and enhancement has been discussed. The analysis of power system performance under different failure conditions has been proposed. Ancillary control equipment like PSS and SVC has been added to power system as to improve the transient stability of power system and damp oscillations.
openaire   +1 more source

Corrosion and Process Analysis of a Preoxidized MgO Recyclate‐Based Cermet Anode in Laboratory‐Scale Na‐Cryolite Molten Salt Electrolysis of Aluminum at 1000°C

Advanced Engineering Materials, EarlyView.
EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk, Farhan Hossain, Felipe A. Garcia Paz, Serhii Yaroshevskyi, Felix Drechsler, Daniel Vogt, Christos G. Aneziris, Alexandros Charitos   +7 more
wiley   +1 more source

Improving Transient Stability of Power System through HVDC Controls

2024 IEEE 22nd Mediterranean Electrotechnical Conference (MELECON)
The growing use of High Voltage Direct Current (HVDC) transmission lines with Voltage Source Converter (VSC) integrated into power systems offers significant advantages for enhancing grid stability. Despite these benefits, there is a lack of research exploring how VSC-HVDC utilization can strengthen overall grid robustness.
Tran, Quoc Tuan, Nguyen, Hung Cuong, Pham, Minh Cong   +2 more
openaire   +1 more source

Toward Low‐Consumable Anodes: Process Simulation and Prospective Life Cycle Assessment of NiFe2O4‐NiO‐Ni‐Cu vs. Prebaked Anodes for Aluminum Production with use of Molten Salt Electrolysis

Advanced Engineering Materials, EarlyView.
Low‐consumable nickel ferrite‐based anodes for the Hall–Héroult process are compared with conventional prebaked carbon anodes using thermodynamic simulation and prospective life cycle assessment under contrasting future electricity system pathways from 2025 to 2050.
Felipe Alejandro Garcia Paz, Ulziikhuu Otgonbayar, Alexander Adamczyk, Farhan Hossain, Daniel Vogt, Johan Berg Pettersen, Alexandros Charitos   +6 more
wiley   +1 more source