Results 191 to 200 of about 747,457 (309)

Sol–Gel Derived Polymer Precursors for Stereolithography of ZrC

Advanced Engineering Materials, EarlyView.
ZrC is a critical material target for extreme temperature conditions. This report describes a protocol for preparing ZrC ceramics via stereolithography and examines the impact of the polymer matrix on carbothermal reduction and mechanical stability of 3D printed ZrC.
Charles J. Rafalko, Evelyn Wang, Michael A. Hickner   +2 more
wiley   +1 more source

Clinical trial coordination of multifaceted ethical and regulatory oversight entities during the COVID-19 public health emergency. [PDF]

Contemp Clin Trials
Gawad A, Mendoza J, Singleton M, Majkowski R, Hopkins E, Carll J, MacInnis C, Amirault D, Jackson B, McBee N, Mould A, Eyzaguirre LM, Pessoa-Gingerich C, Shoham S, Sullivan D, Lane K.   +15 more
europepmc   +1 more source

Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere

Advanced Engineering Materials, EarlyView.
In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger, Lienhard Wegewitz, Wolfgang Maus‐Friedrichs   +2 more
wiley   +1 more source

Corrosion and Process Analysis of a Preoxidized MgO Recyclate‐Based Cermet Anode in Laboratory‐Scale Na‐Cryolite Molten Salt Electrolysis of Aluminum at 1000°C

Advanced Engineering Materials, EarlyView.
EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk, Farhan Hossain, Felipe A. Garcia Paz, Serhii Yaroshevskyi, Felix Drechsler, Daniel Vogt, Christos G. Aneziris, Alexandros Charitos   +7 more
wiley   +1 more source

Proceedings of the Summit for Perinatal Excellence 2025. [PDF]

BMC Proc
europepmc   +1 more source

Nutrition in early life, epigenetics and lifelong health - evidence from cohort and intervention studies. [PDF]

Proc Nutr Soc
Godfrey KM, Costello P, El-Heis S.
europepmc   +1 more source

Country Report Belgium [PDF]

, 2008
van Puyenbroeck, Laurens, Vermeulen, Gert   +1 more
core  

Impact of Sustainable Binders Based on Lignin and Collagen on the Volume Stability and Mechanical Properties of MgO‐C Refractories with MgO‐C Recyclates

Advanced Engineering Materials, EarlyView.
Collagen hydrolysate is evaluated as a sustainable binder for MgO‐C refractories. Its thermally induced cross‐linking and gas release lead to expansion and cracking in large bricks, but tailored batches with lignin, recyclates, or fine graphite improve the gas release while thermal treatment and stability.
Till M. J. Stadtmüller, Florian Kerber, Kirsten Moritz, Steffen Dudczig, Konstantin Kraushaar, Thomas Schemmel, Jana Hubálková, Patrick Gehre, Christos G. Aneziris   +8 more
wiley   +1 more source

LegalEye: Multimodal Court Deception Detection Across Multiple Languages. [PDF]

Behav Sci (Basel)
Baldivas RIA, Sreenivasan N, Kang SY, Miller AM, Chacko M, Krishnan S, Ayala C, Ayala E, Kim D.   +8 more
europepmc   +1 more source

Tselerant form of criminal pre-trial proceedings

BULLETIN of L.N. Gumilyov Eurasian National University. Law Series, 2019
openaire   +2 more sources