Results 61 to 70 of about 17,754,204 (193)
An Optimal Current Observer for Predictive Current Controlled Buck DC-DC Converters
In digital current mode controlled DC-DC converters, conventional current sensors might not provide isolation at a minimized price, power loss and size. Therefore, a current observer which can be realized based on the digital circuit itself, is a possible substitute.
Min, Run +5 more
openaire +3 more sources
Permanent magnet synchronous motors (PMSMs) are widely used in industrial applications due to their high efficiency, compact structure, and excellent dynamic performance.
Benkaihoul Said +8 more
doaj +1 more source
PREDICTIVE CURRENT CONTROLLER WITH MTPA CONTROL STRATEGY – SIMULATION RESULTS
Electric and hybrid vehicle drive systems are commonly equipped with Permanent Magnet Synchronous Motors, because they offer high efficiency in broad range of speed and torque, and also due to special current development techniques they can work with ...
Rafał Piotuch
doaj +1 more source
Current Dynamically Predicting Control of PMSM Targeting the Current Vectors
This paper present a current predicting control method for PMSM (permanent magnet synchronous motor) to improve the tracking performance of stator current, which regards the current vector as the control target. Solving the model state equation in the static frame (α-β frame), the dynamic change of current vector will be gained as three independent ...
Hexu Sun, Kai Jing, Yan Dong, Yi Zheng
openaire +2 more sources
Finite control-set model predictive control (FCS-MPC) has been extensively applied to multilevel converters (MCs) due to its simplicity, fast dynamics, and ability to handle multiple objectives.
Cristian Castillo +6 more
doaj +1 more source
Model predictive control and sliding mode control for current sharing in microgrids
This paper deals with the design of a hierarchical control scheme for complex islanded Alternate Current (AC) microgrids. The proposed solution relies on the combined use of Model Predictive Control (MPC) and Sliding Mode Control (SMC). The model of the microgrid includes several Distributed Generation Units (DGus), affected by unknown load dynamics ...
Gian Paolo Incremona +3 more
openaire +1 more source
Vector control of an induction machine (IM) is typically performed by using cascade control structures with conventional linear proportional–integral (PI) controllers, the inner loop being designed for current control and the outer loop for rotor flux ...
Madalin Costin, Corneliu Lazar
doaj +1 more source
The predictive current controller has arisen as a practicable technique for operating multiphase machines due to its fast dynamic response, control flexibility, and overall good performance.
Magno Ayala +7 more
doaj +1 more source
Introduction. Recently, photovoltaic (PV) systems are increasingly favored for converting solar energy into electricity. PV power systems have successfully evolved from small, standalone installations to large-scale, grid-connected systems.
A. Zorig +3 more
doaj +1 more source
There is an increasing interest in achieving global climate change mitigation targets that target environmental protection. Therefore, electric vehicles (as linear metros) were developed to avoid greenhouse gas emissions, which negatively impact the ...
Mohamed. A. Ghalib +4 more
doaj +1 more source

