Results 231 to 240 of about 250,500 (300)

On the Influence of Antioxidants and Recycled MgO–C Source Material on the Mechanical Properties of Carbon‐Bonded Magnesia Refractories

Advanced Engineering Materials, EarlyView.
The presented study focuses on the fracture behaviour of carbon‐bonded magnesia MgO–C refractories, where environmentally friendly fructose, collagen and lignin serve as temporary binding agents. The partial substitution of the source material with recycled MgO–C reduces the fracture resistance, which can be counteracted by the additional introduction ...
Marc Neumann, Tom Weber, Jana Hubálková, Florian Kerber, Dinesh Kumar Gunasekar, Hans Jelitto, Christos G. Aneziris   +6 more
wiley   +1 more source

Toxicity Effects and Mechanism of Chemical Stress on <i>Pomacea canaliculata</i>. [PDF]

Biology (Basel)
Zhou H, Zou M, Zhou Z, Li C.
europepmc   +1 more source

Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere

Advanced Engineering Materials, EarlyView.
In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger, Lienhard Wegewitz, Wolfgang Maus‐Friedrichs   +2 more
wiley   +1 more source

Guideline-Concordant Sedative and Analgesia Use in Critically Ill Patients Receiving Sustained Neuromuscular Blockade. [PDF]

Crit Care Explor
Feeney ME, Canova AE, Law AC, Walkey AJ, Bosch NA.   +4 more
europepmc   +1 more source

Population of Nonmetallic Inclusions in Liquid High‐Silicon Electrical Steel in Contact With MgO–C Refractories Based on Recyclates and Environmentally Friendly Binders

Advanced Engineering Materials, EarlyView.
The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert, Matheus Roberto Bellé, Florian Kerber, Dinesh Kumar Gunasekar, Hans‐Jörn Weddige, Christos G. Aneziris, Olena Volkova   +6 more
wiley   +1 more source

Amplifying missing voices in healthcare research: an AI framework for co-production of PPIE. [PDF]

Front Digit Health
Steele A, Strachan F, Milligan C, Ibbotson T.   +3 more
europepmc   +1 more source

Dynamic Testing of Cold Gas Sprayed Bipolar Plates–Porous Transport Layer Coating System in Proton Exchange Membrane Water Electrolysis

Advanced Engineering Materials, EarlyView.
Through direct application of porous transport layer (PTL) on the bipolar plate (BPP) with thermal spraying, the interfacial contact resistance is improved. With the cold gas sprayed BPP–PTL coating system, a proton exchange membrane water electrolysis cell with a cell voltage of Ucell = 1.9 V can be operated up to i = 2.5 A/cm2 in a dynamic mode ...
Kirsten Bobzin, Marvin Erck, Kevin Jasutyn, Katja Radermacher, Andreas Bund, Mario Kurniawan   +5 more
wiley   +1 more source

The Convergence of Precision and Cognition in Biomedical AI. [PDF]

Bioengineering (Basel)
Pinto-Coelho L, Teixeira JP, Carmo JP.
europepmc   +1 more source

Molecular crowding effects on protein stability in a bacterial proteome. [PDF]

Sci Rep
McKeever K, Dillon ET, Wynne K, Cagney G.   +3 more
europepmc   +1 more source

When Pills Get a Pass and Lifestyle Treatments Don't: Misapplication of Phase III Logic to Phase IV Evaluation in Health Care. [PDF]

J Eval Clin Pract
Krachler B, Norberg M, Weinehall L, Janlert U, Kristenson M.   +4 more
europepmc   +1 more source