Results 11 to 20 of about 20,128 (231)
MATEC Web of Conferences, 2017 There are a large number of civil engineering structures where the important structural elements are loaded by large tensile forces. In many practical cases, it is significant to know the current value of tensile force or prestressed stress in these ...
Klier Tomáš +5 more
doaj +1 more source
Reduction in Mode-I SIF of an Edge Cracked C-Shaped Specimen Using Piezoelectric Actuator [PDF]
E3S Web of Conferences, 2023 The focus of the current research is on the feasibility of an adhesively bound piezoelectric actuator in the active repair of an edge-cracked C-shaped specimen.
Pattanayak Sourav, Pohit Goutam
doaj +1 more source
Applied Rheology, 2018 The creep behavior of a new type epoxy resin adhesive which is room-temperature cured and used for reinforcing engineering structures was studied. The tensile strength of the adhesive has reached the desired values for the structural adhesive used for ...
Li Hui, Luo Yingshe, Hu Donglan
doaj +1 more source
MATEC Web of Conferences, 2015 The old cement pavement damage status directly affect the design of the paving renovation. Based on the state of the old road investigation, combined with the research data at home and abroad, use the control index that average deflection, deflection ...
Jiang Ruinan +3 more
doaj +1 more source
Applied Sciences, 2018 The concrete stress behavior and cause of cracking at the anchorage zones of top and bottom slabs of a post-tensioned prestressed concrete box beam were studied.
Weizhong Mao +3 more
doaj +1 more source
EXPERIMENTAL SETUP FOR MODELING AND STUDY OF COMPLEX STRESS STATE IN FERROMAGNETIC MATERIALS
Приборы и методы измерений, 2016 Most of the load experiencing parts operate in a complex state of stress (СSS). The article describes the device layout diagram for modeling a СSS in a ferromagnetic material and the development of monitoring methods.
V. N. Busko, G. G. Vlasov
doaj +1 more source
Tension and compression effect on mechanical properties of Fe and B2
Materials Research Express, 2020 The elastic constants, ideal strength, band structure and electronic density state of Fe and B2 under tension and compression were studied by using the first principle.
Gang Huang, Qingdong Zhang, Shuo Li
doaj +1 more source
Energy Exploration & Exploitation, 2023 This article presents an integrated approach for theoretical analysis and numerical modeling to investigate the mechanism of roof presplitting and its reasonable parameters in the hard roof and longwall top-coal caving face.
Haosen Wang +5 more
doaj +1 more source
Mechanical Properties of DO3 Based on First Principles
Crystals, 2020 The elastic constants, ideal strength, band structure and electronic density state of Fe3Si (DO3) under triaxial tension and triaxial compression were studied using the first principle. The structural parameters calculated at zero pressure are consistent
Qingdong Zhang, Gang Huang, Shuo Li
doaj +1 more source
Next MaterialsElucidating the degradation mechanism of inorganic materials in special service environments such as ocean environment has important scientific and engineering significance.
Jinbo Yang, Ze Zhang, Yu Zhang
doaj +1 more source