Results 21 to 30 of about 108,330 (269)
Applied Rheology, 2018 The creep behavior of a new type epoxy resin adhesive which is room-temperature cured and used for reinforcing engineering structures was studied. The tensile strength of the adhesive has reached the desired values for the structural adhesive used for ...
Li Hui, Luo Yingshe, Hu Donglan
doaj +1 more source
MATEC Web of Conferences, 2015 The old cement pavement damage status directly affect the design of the paving renovation. Based on the state of the old road investigation, combined with the research data at home and abroad, use the control index that average deflection, deflection ...
Jiang Ruinan +3 more
doaj +1 more source
Applied Sciences, 2018 The concrete stress behavior and cause of cracking at the anchorage zones of top and bottom slabs of a post-tensioned prestressed concrete box beam were studied.
Weizhong Mao +3 more
doaj +1 more source
EXPERIMENTAL SETUP FOR MODELING AND STUDY OF COMPLEX STRESS STATE IN FERROMAGNETIC MATERIALS
Приборы и методы измерений, 2016 Most of the load experiencing parts operate in a complex state of stress (СSS). The article describes the device layout diagram for modeling a СSS in a ferromagnetic material and the development of monitoring methods.
V. N. Busko, G. G. Vlasov
doaj +1 more source
Tension and compression effect on mechanical properties of Fe and B2
Materials Research Express, 2020 The elastic constants, ideal strength, band structure and electronic density state of Fe and B2 under tension and compression were studied by using the first principle.
Gang Huang, Qingdong Zhang, Shuo Li
doaj +1 more source
Mechanical Properties of DO3 Based on First Principles
Crystals, 2020 The elastic constants, ideal strength, band structure and electronic density state of Fe3Si (DO3) under triaxial tension and triaxial compression were studied using the first principle. The structural parameters calculated at zero pressure are consistent
Qingdong Zhang, Gang Huang, Shuo Li
doaj +1 more source
Energy Exploration & Exploitation, 2023 This article presents an integrated approach for theoretical analysis and numerical modeling to investigate the mechanism of roof presplitting and its reasonable parameters in the hard roof and longwall top-coal caving face.
Haosen Wang +5 more
doaj +1 more source
Improving mechanical properties of novel flax/tannin composites through different chemical treatments [PDF]
, 2015 Due to the inherent environmental benefits of using renewable materials, mimosa tannin resin (a natural phenolic resin) reinforced by flax fibres could offer desirable characteristics (lightweight, economic and low environmental impact) aiming at ...
Abhyankar, Hrushikesh +4 more
core +1 more source
Flow-Induced Stresses and Displacements in Jointed Concrete Pipes Installed by Pipe Jacking Method [PDF]
, 2019 Transient flows result in unbalanced forces and high pressure in pipelines. Under these conditions, the combined effects of flow-induced forces along with sudden pipe displacements can create cracks in the pipeline, especially at the junctions.
Ahmad, Sajjad +3 more
core +2 more sources
Nuclear Materials and Energy, 2020 Welding is essential to construction and safe operation of fusion reactors. Besides fusion materials themselves, small specimen test technologies (SSTT) are also essential to evaluate bonding properties of the joints for fusion application.
Haiying Fu +11 more
doaj +1 more source