Results 71 to 80 of about 184,840 (314)
Recent Advances of Slip Sensors for Smart Robotics
This review summarizes recent progress in robotic slip sensors across mechanical, electrical, thermal, optical, magnetic, and acoustic mechanisms, offering a comprehensive reference for the selection of slip sensors in robotic applications. In addition, current challenges and emerging trends are identified to advance the development of robust, adaptive,
Xingyu Zhang +8 more
wiley +1 more source
Aims: The war leads to a lot of physical damage. The most common level of amputation is the upper limb, cutting off at the below elbow. The aim of this study was to investigate satisfaction of veterans with trans-radial amputations from myoelectric ...
J. Heidari +3 more
doaj
Assessment of Noise Levels of Equipment Used in the Practical Dental Teaching Activities
Introduction. Practical activities in dentistry are characterized by a high noise level that can have adverse effects on the hearing health of professors, students, and teaching staff.
Meriem Amine +5 more
doaj +1 more source
Prosthesis-Patient Mismatch after Surgical Aortic Valve Replacement: Neither Uncommon nor Harmless
Prosthesis-patient mismatch (PPM) after surgical aortic valve replacement (SAVR) is an issue that has been overlooked (not to say neglected). Cardiac surgeons must bear in mind that this is a real problem that we must tackle. The purpose of this paper is
Alexandre Motta Menezes (4642921) +8 more
core +1 more source
An Energy-Efficient, Dynamic Voltage Scaling Neural Stimulator for a Proprioceptive Prosthesis [PDF]
This paper presents an energy-efficient neural stimulator capable of providing charge-balanced asymmetric pulses. Power consumption is reduced by implementing a fully-integrated DC-DC converter that uses a reconfigurable switched capacitor topology to ...
Ian Williams +3 more
core +1 more source
3D Printing of Stretchable, Compressible and Conductive Porous Polyurethane for Soft Robotics
A 3D‐printable porous dopamine‐polyurethane acrylate elastomer results in conductive, stretchable, and compressible structures that can be metallized in situ through catechol‐mediated silver reduction. The resulting material function as both compliant soft robot with a and strain sensors without complex assemblies, enabling fully 3D‐printed soft ...
Ouriel Bliah +3 more
wiley +1 more source
Skin‐Like Tri‐Modal Sensors Based on Soft Piezoelectric and Ionic Composites
Inspired by the multimodal perception of human skin, a soft, skin‐like tri‐modal sensor is presented. The device incorporates an ionically conductive, piezoelectric, elastic composite as its active layer, enabling independent detection of temperature, static strain, and dynamic strain within a single two‐terminal architecture.
Liren Wang +9 more
wiley +1 more source
Effect of denture quality on perioral muscle activity during speech
This study aimed to evaluate the electromyographic activity of the orbicularis oris muscle in patients using clinically inadequate conventional dentures before and after the insertion of clinically acceptable new convencional denture. Six patients, using
Carla Moreto Santos +6 more
doaj +1 more source
Glaucoma is a neurological disorder leading to blindness initially through the loss of retinal ganglion cells, followed by loss of neurons higher in the visual system. Some work has been undertaken to develop prostheses for glaucoma patients targeting tissues along the visual pathway, including the lateral geniculate nucleus (LGN) of the thalamus, but ...
Hieu T. Nguyen +6 more
openaire +4 more sources
Multimodal Haptic Perception Through Synergistic Nanocomposite Sensor Arrays
Multi‐modal fingertip haptics are advanced through a bioinspired &vertical‐via' electronic skin architecture. A confined PDMS/MWCNT/NiNP nanocomposite, sitting at the percolation threshold, enables tactile, thermal, and magnetic sensing. A unique via‐density gradient and dedicated &Un‐Touch' reference nodes provide robust spatial resolution and signal ...
Amos Bardea, Fernando Patolsky
wiley +1 more source

