Results 41 to 50 of about 16,379 (267)
A low‐Pt catalyst supported on zeolitic imidazolate framework (ZIF‐8)‐derived porous carbon and graphite is integrated with a halide perovskite photovoltaic, yielding cathodes that achieve a high photocurrent density (∼20 mA cm−2) under simulated sunlight and exhibit remarkable stability in acidic media over several days, thereby demonstrating a ...
Na Yeong Oh +12 more
wiley +1 more source
An ionic naphthalimide AIE photosensitizer (PS), TPAPV‐NIM‐M, anchors to cellular and bacterial membranes, emits in the far‐red/near‐infrared (NIR) region, and efficiently generates reactive oxygen species (ROS) under white light. Its membrane‐localized photodynamic action drives apoptosis/ferroptosis‐mediated tumor suppression and broad‐spectrum ...
Sayed Mir Sayed +3 more
wiley +1 more source
Analysis of Photovoltaic String Failure and Health Monitoring with Module Fault Identification
In this paper, photovoltaic (PV) string failure analysis and health monitoring of PV modules based on a low-cost self-powered wireless sensor network (WSN) are presented.
Ahmad Rivai +3 more
doaj +1 more source
Investigating the Effect of Inclination Angle of Magnetic Field Vector on Silicon PV Modules
In earlier studies, we have shown theoretically and experimentally that magnetic fields (MFs) have negative impact on silicon PV module (photovoltaic module). A noticeable decline in photocurrent with a slight increase in photovoltage was observed. Also,
Dioari Ulrich Combari +5 more
doaj +1 more source
The purpose of this study is to improve the electrical performance of the photovoltaic (PV) module by using the sunlight concentration and cooling technique.
Swar A. Zubeer, Omar Mhohammed Ali
doaj +1 more source
Electrical Modeling of Bifacial PV Modules [PDF]
Although the bifacial photovoltaic (PV) module is now a mature technology, there still exists a gap in the literature on its electrical modeling and equivalent circuit representation. Most published studies have mainly focused on the photocurrent while overlooking other crucial parameters for the electrical response of the module.
Preeti Kumari Sahu +3 more
openaire +1 more source
Fluorene‐functionalized spiro‐phenothiazine (PTZ‐Fl) exhibits strong Li+ affinity and thermal stability, enabling a PCE of 25.75% in small‐area cells and 22.07% in 25 cm2 modules. Under ISOS‐L3 conditions, PTZ‐Flbased devices retain over 80% efficiency after 1000 hours, demonstrating superior stability and scalability compared to spiro‐OMeTAD for next ...
Javier Urieta‐Mora +17 more
wiley +1 more source
Reduction of temperature in silicon photovoltaic module using thermal radiation coating
The temperature of solar cells increases under the actual operating conditions, and the conversion efficiency of solar cells decreases with increasing temperature.
Nakamura Satoshi, Nishioka Kensuke
doaj +1 more source
Performance analysis of thermosyphon hybrid photovoltaic thermal collector
The conversion of solar irradiance into electricity by a photovoltaic module (PV) is 6– 7% of the incoming energy from the sun depending on the type of technology and the environmental parameters.
N. Marc-Alain Mutombo +2 more
doaj +1 more source
Temperature based maximum power point tracking for photovoltaic modules
In this article authors propose a temperature based Maximum Power Point Tracking algorithm (MPPT). Authors show that there is an optimal current vs maximum power curve that depends on photovoltaic (PV) module temperature.
Josean Ramos-Hernanz +5 more
doaj +1 more source

