Results 101 to 110 of about 10,494 (268)
Influence of Rack Side Bending on Rack Transmission
Shiyou jixie, 2019 Manufacturing processes or loads can cause bending deformation of the rack and affect the normal transmission of the rack and pinion. To address the problem, the geometric analysis on the side bending of the rack is carried out.
Wang Keqiang +5 more
doaj
A Review of Footstep Energy Harvesting Systems
IEEE AccessRecently, energy harvesting through human locomotion has emerged as a promising source of clean energy for fueling low-power smart electronic devices.
Kritesh A. Chandra +5 more
doaj +1 more source
Motor-driven rack-positioning device [PDF]
, 1975 Ramped clutch plate prevents damage to gear traing and provides ample linear motion for actuation of microswitch. Operation of device is not affected by number of revolutions which pinion shaft must make to produce required translations.
Crissey, M. E.
core +1 more source
Jixie qiangduThe load capacity of the rack and pinion mechanism is limited by the contact strength of the gear tooth surface.In order to improve its load capacity,multiple pairs of gears and single rack meshing were adopted.In order to simplify the structure of the ...
doaj
SIDE-STICK CONTROL OF POWER RACK AND PINION STEERING SYSTEM [PDF]
, 2006 Mostafa Sh. Asfoor +2 more
openalex +1 more source
Design and Development of Solar Panel Cleaning System [PDF]
, 2015 Solar energy is the most abundant source of energy for all the forms of life on the planet Earth. It is also the basic source for all the sources of energy except Nuclear Energy.
Mobin, Shaikh Tariq
core
Angular Timing Error of a Gear Set [PDF]
, 1997 Alessandro Vigliani, Henriot, Niemann
core +1 more source
Door assembly with shear layer control aperture [PDF]
, 1996 There is described a vehicle door assembly with shear layer control for controlling the airflow in and around an aperture in the vehicle fuselage. The vehicle door assembly consists of an upper door and a lower door, both slidably mounted to the exterior
Fluegel, Kyle G. +2 more
core +1 more source
Interaction of rack-and-pinion lock parts under external load
, 2019 E. L. Gusev, Viktor Krasavtsev
openalex +1 more source
Shiyou jixie, 2019 The rack and pinion system is the most commonly used lifting system for jack-up offshore platforms. There are relatively few studies on the influence of rack structure on the hydrodynamic characteristics of truss-type legs.
Li Xiangkun +3 more
doaj