Results 101 to 110 of about 285,492 (338)

Investigating the Effects of Build Height on Mechanical Behavior of Large‐Scale Laser Wire Directed Energy Deposited Nickel Titanium Alloy

open access: yesAdvanced Engineering Materials, EarlyView.
Laser wire directed energy deposition process was leveraged to fabricate large scale NiTi alloy wall. Evaluation of build‐height‐dependent tribo‐mechanical properties revealed significant differences in location specific sample characteristics. The middle region achieved optimal performance (superior wear resistance, balanced strength‐ductility ...
Hyunsuk Choi   +5 more
wiley   +1 more source

Preconditioned Bi-Conjugate Gradient Method for Radiative Transfer in Spherical Media

open access: yes, 2009
A robust numerical method called the Preconditioned Bi-Conjugate Gradient (Pre-BiCG)method is proposed for the solution of radiative transfer equation in spherical geometry.A variant of this method called Stabilized Preconditioned Bi-Conjugate Gradient ...
Asensio Ramos   +24 more
core   +2 more sources

A MEMS Device Capable of Measuring Near-Field Thermal Radiation between Membranes

open access: yesSensors, 2013
For sensors constructed by freestanding membranes, when the gap between a freestanding membrane and the substrate or between membranes is at micron scale, the effects of near-field radiative heat transfer on the sensors’ thermal performance should be ...
Changyu Sun   +3 more
doaj   +1 more source

Enhanced Oxidation and Thermal Shock Resistance of N‐type Mg2Si0.89(Sn0.1,Sb0.01) Thermoelectric Material via Cr0.9Si0.1 Coating

open access: yesAdvanced Engineering Materials, EarlyView.
Cr0.9Si0.1 protective coatings are developed to enhance the thermal‐shock and oxidation resistance of Mg2Si0.89(Sn0.1,Sb0.01) thermoelectric (TE) materials. The coating forms a dense and adherent barrier that suppresses oxygen diffusion and mitigates mechanical degradation during cyclic oxidation, demonstrating its potential to improve the long‐term ...
Mikdat Gurtaran   +3 more
wiley   +1 more source

Prediction of the 21-cm signal from reionization: comparison between 3D and 1D radiative transfer schemes

open access: yes, 2017
Three-dimensional radiative transfer simulations of the epoch of reionization can produce realistic results, but are computationally expensive. On the other hand, simulations relying on one-dimensional radiative transfer solutions are faster but limited ...
Choudhury, T. Roy   +5 more
core   +1 more source

SNICAR-ADv4: a physically based radiative transfer model to represent the spectral albedo of glacier ice [PDF]

open access: gold, 2022
Chloe A. Whicker   +5 more
openalex   +1 more source

Design and Prototyping of Topology‐Optimized, Additively Manufactured Lightweight Components for Space Robotic Systems: A Case Study

open access: yesAdvanced Engineering Materials, EarlyView.
The results demonstrate a simulation‐driven workflow that applies LSB topology optimization with additive manufacturing constraints to mission‐specific load cases, integrating European Cooperation for Space Standardization compliant verification and manufacturability to develop structurally efficient rover suspension components.
Stelios K. Georgantzinos   +11 more
wiley   +1 more source

Mechanically Deposited Wear‐Resistant Amorphous Zr55Cu30Al10Ni5 Coatings

open access: yesAdvanced Engineering Materials, EarlyView.
Mechanically deposited from glassy ribbons, the Zr55Cu30Al10Ni5 amorphous coating formed a hard, continuous layer on AISI 1010 steel, tripling substrate hardness, lowering friction, and reducing wear. Despite its rough surface, it showed friction and wear behavior comparable to the crystalline alloy, highlighting its strong potential as a durable ...
Tales Ferreira   +8 more
wiley   +1 more source

Home - About - Disclaimer - Privacy