Results 201 to 210 of about 10,379 (248)

Ratcheting behavior of articular cartilage under cyclic unconfined compression

Materials Science and Engineering C, 2015
The ratcheting deformation of articular cartilage can produce due to the repeated accumulations of compressive strain in cartilage. The aim of this study was to investigate the ratcheting behavior of articular cartilage under cyclic compression. A series of uniaxial cyclic compression tests were conducted for online soaked and unsoaked cartilage ...
Li-Lan Gao, Hong Gao
exaly   +3 more sources

Fatigue and ratcheting behaviors of CP-Ti at room temperature

Materials Science & Engineering A: Structural Materials: Properties, Microstructure and Processing, 2014
Abstract Based on the careful analyses of the stress controlled fatigue behavior of commercially pure titanium (CP-Ti) at room temperature, two stress regions can be evidently identified by cycle strain range, ratcheting strain, min ratcheting strain rate, ratcheting failure strain and fracture morphologies.
Zhou Chang
exaly   +2 more sources

Uniaxial and biaxial ratcheting behavior of ultra-high molecular weight polyethylene

Materials Science and Engineering C, 2018
Experimental studies were conducted to investigate the uniaxial and biaxial ratcheting behaviors of Ultra-high molecular weight polyethylene (UHMWPE). The effects of stress amplitude, stress rate and hydroxyapatite content on uniaxial ratcheting behavior were studied firstly.
Hong Gao, Lilan Gao, Zhe Zhang
exaly   +3 more sources

Uniaxial ratchetting behavior of vulcanized natural rubber

Polymer Engineering & Science, 2007
AbstractMost of rubber engineering components endure cyclic loading during their service, and a nonzero mean stress during cyclic loading may cause an accumulation of strain which is known as ratchetting phenomenon. In order to study the ratcheting effect of rubber, a series of uniaxial ratchetting experiments were conducted on vulcanized natural ...
Weiwei Yu   +4 more
openaire   +1 more source

Thermal Ratcheting Criteria and Behavior of Piping Elbows

Journal of Pressure Vessel Technology, 1990
A thermal ratcheting test was performed using an elbow model test specimen subjected to sustained primary load and cyclic thermal transient strains. Under severe loading conditions incremental longitudinal strains are observed in the region where a circumferential angle is around ± π/9 from the side of the elbow, while the elbow cross section was ...
M. Ueda, T. Kano, A. Yoshitoshi
openaire   +1 more source

Ratchet-induced anisotropic behavior of superparamagnetic microdroplet

Applied Physics Letters, 2009
Microscale ratchet structured surfaces were coated with nanoparticles, which resulted in anisotropic behavior of superparamagnetic microdroplet by magnetic field actuation. This ratchet structure enables superparamagnetic microdroplets to generate the anisotropic behavior through the alternative external magnetic field.
Jihua Zhang   +3 more
openaire   +1 more source

Ratcheting Behavior of Sintered Copper Joints for Electronic Packaging

IEEE Transactions on Components, Packaging and Manufacturing Technology, 2021
This study experimentally investigated the whole-life ratcheting behavior of sintered copper joints with consideration of the effects of stress rate, stress amplitude, mean stress, maximum stress, and stress ratio. Deformation of joints under cyclic load was measured by a noncontact displacement detecting system.
Yanliang Shan   +6 more
openaire   +1 more source

Home - About - Disclaimer - Privacy