Results 171 to 180 of about 1,011,150 (288)

Interaction between Molten Al‐Killed Mn–B Steel and Carbon‐Bonded MgO Refractories Based on Recyclates

Advanced Engineering Materials, EarlyView.
High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé, Lukas Neubert, Anton Yehorov, Till M. J. Stadtmüller, Christos G. Aneziris, Olena Volkova   +5 more
wiley   +1 more source

Sensorless Direct Field-Oriented Control of Induction Motor Drive Using Artificial Neural Network-Based Reactive Power MRAS. [PDF]

Sensors (Basel)
Kubatko M, Bielesz D, Kirschner S, Hamani K, Kuchar M, Mrovec T, Prazenica M.   +6 more
europepmc   +1 more source

MFRED, 10 second interval real and reactive power for groups of 390 US apartments of varying size and vintage. [PDF]

Sci Data, 2020
Meinrenken CJ, Rauschkolb N, Abrol S, Chakrabarty T, Decalf VC, Hidey C, McKeown K, Mehmani A, Modi V, Culligan PJ.   +9 more
europepmc   +1 more source

Facilitating Expedited Drug Approval—the Past, Present, and Future of Clinical Trials for Pediatric Rheumatic Disease

Arthritis Care &Research, EarlyView.
Pamela F. Weiss, Hermine I. Brunner
wiley   +1 more source

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

Advanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti, Finn‐Lennard Janthur, Selina Raumel, Sascha Jan Zimmermann, Sarah Seffer, René Gustus, Sebastian Herbst, Marc C. Wurz, Ludger Overmeyer, Wolfgang Maus‐Friedrichs, Hans Jürgen Maier, Florian Nürnberger   +11 more
wiley   +1 more source

Optimization the stochastic optimal reactive power dispatch with renewable energy resources using a modified dandelion algorithm. [PDF]

PLoS One
Agouzoul N, Oukennou A, Elmariami F, Ebeed M, Boukherouaa J, Gadal R, Aly M, A Mohamed E.   +7 more
europepmc   +1 more source

A New Fractional Particle Swarm Optimization with Entropy Diversity Based Velocity for Reactive Power Planning. [PDF]

Entropy (Basel), 2020
Khan MW, Muhammad Y, Raja MAZ, Ullah F, Chaudhary NI, He Y.   +5 more
europepmc   +1 more source

Characterization of Nitinol Produced by Laser Powder Bed Fusion for Mechanical Metamaterial Applications

Advanced Engineering Materials, EarlyView.
Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek, Jakub Hurník, Miroslav Šmíd, Ondřej Zobač, Melanie Todt, Daniel Koutný   +5 more
wiley   +1 more source

Control strategy evaluation for reactive power management in grid-connected photovoltaic systems under varying solar conditions. [PDF]

Sci Rep
Adak S.
europepmc   +1 more source

Optimized Power System Management Scheme for LSS PV Grid Integration in Malaysia Using Reactive Power Compensation Technique. [PDF]

Glob Chall, 2020
Mohanan M, Go YI.
europepmc   +1 more source